User manual DELONGHI DFH443T

[. . . ] Do not insert or allow foreign objects to enter any ventilation opening as this may cause an electric shock, fire or damage the appliance. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. A fan heater has hot or arcing or sparking parts inside. [. . . ] If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. ELECTRIC CONNECTION The fan heater must be connected to a properly polarized A/C 110/120 V household outlet in perfect working condition. Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater is plugged in. When you plug in the appliance, the red pilot light will illuminate (Fig. 1). INSTALLATION The fan heater can be easily positioned on any horizontal support surface in an upright position. FAN HEATER CONTROLS: thermostat dial pointer red pilot light AM AUTO MAN °F TIMER ON yellow lamp O Fig. 1 / 3 GB 10-05-2001 9:00 Pagina 4 OPERATION AND USE 1) SETTING THE CLOCK For the first time, set the clock to the correct time, proceeding as follows: · Press the button "hour" until the display shows the hours for the correct time and AM or PM, then release the button (fig. 1). · Press the button "min" until the display shows the minutes for the correct time, then release the button (fig. When setting the correct time, the numbers will flash on the display. The flashing of the numbers will continue for a few seconds after the adjustment has finished then stop on the correct time and the clock start working. (Keep both pushbuttons pressed for more than 3 seconds to move through the hours and minutes in fast mode). To change the time, press pushbuttons "hour" for at least 5 seconds, then proceed as above to modify both hours and minutes. AM AUTO °F O current time room temperature 2) MANUAL FUNCTIONING To operate the heater without timer press the "ON MODE" button. from 45 mins to 1hr, both programmes will operate for 1 hr). Now set the comfort temperature as previously described by using the thermostat dial. The power level will automatically be set to maximum and will reduce to the lower power levels as required. The heater will switch on automatically every day at the preset time for the designated time period and will automatically maintain the selected confort temperature. If you wish to cancel a programme depress the " AUTO" button and then the "hour" and "min" buttons until the display shows: O 6 GB 10-05-2001 9:00 Pagina 7 Time Override If you wish to operate the heater without timer, press the "ON MODE" button. The yellow timer pilot light will go off. 5) MODELS WITH ROTATING BODY This appliance is fitted with a motorized base and a rotating body. To distribute the air flow over a larger area, press the oversized switch (Fig. When activated, the appliance will oscillate from right to left over an angle of approximately 30°. To terminate oscillating, simply press the oversized switch again. Fig. 3 IMPORTANT You must leave the heater plugged in and switched on at the mains socket to keep the heaters memory programmed. [. . . ] This warranty shall apply only if the appliance is used in accordance with the factory directions which accompany it, and on an Alternating Current (AC) circuit. This warranty runs for one year from the date of delivery and applies only to the original purchaser for use. This warranty does not cover defects or damage of the appliance which result from repairs or alterations to the appliance outside our factory or authorized service centers, nor shall it apply to any appliance which has been subject to abuse, misuse, negligence or accidents. Also, consequential and incidental damages resulting from the use of this product or arising out of any breach of contract or breach of this warranty are not recoverable under this warranty. [. . . ]