User manual DELONGHI DFH480M

[. . . ] Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. To disconnect the appliance, turn controls to off, then remove plug from outlet. Connect to properly polarized outlets only. [. . . ] 1 / 3 GB 10-05-2001 9:00 Pagina 4 OPERATION AND USE 1) SETTING THE CLOCK For the first time, set the clock to the correct time, proceeding as follows: · Press the button "hour" until the display shows the hours for the correct time and AM or PM, then release the button (fig. 1). · Press the button "min" until the display shows the minutes for the correct time, then release the button (fig. When setting the correct time, the numbers will flash on the display. The flashing of the numbers will continue for a few seconds after the adjustment has finished then stop on the correct time and the clock start working. (Keep both pushbuttons pressed for more than 3 seconds to move through the hours and minutes in fast mode). To change the time, press pushbuttons "hour" for at least 5 seconds, then proceed as above to modify both hours and minutes. AM AUTO °F O current time room temperature 2) MANUAL FUNCTIONING To operate the heater without timer press the "ON MODE" button. By pressing the "ON MODE" button one or more times, the appliance will select the operating heating power, as follows: AM MAN °F Maximum power AM MAN Medium power °F AM MAN °F Minimum power AM MAN °F Fan only (summer ventilation) AM MAN Off O °F 4 GB 10-05-2001 9:00 Pagina 5 If Maximum power has been selected, adjust the thermostat dial (Fig. 1) to the desired comfort temperature, from 42° and 95° F (5°C to 35°C). By turning the thermostat dial the display will show the selected temperature. In addition, the smaller characters on the right-hand side of the display will indicate the actual room temperature (see figure). MAN selected temperature °F room temperature This heater has Electronic Climate Control which automatically monitors and selects the ideal power setting to maintain your chosen temperature. If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected temperature. The unit will automatically maintain the temperature at a constant level, by switching between maximum, medium and minimum power. If the room temperature exceeds the selected temperature level, the appliance will switch off. The appliance will switch on automatically again when the room temperature falls below the selected temperature level. If medium power level has been selected using the "ON MODE" button, the appliance will modulate between medium and minimum power to maintain a selected temperature. 3) ANTIFREEZE FUNCTION Press the "ON MODE" button to select the "P max" power level. Set the thermostat dial to the " " position (Fig. The display will show 42°F (see figure). When set in this way, the appliance will switch on automatically only if the room temperature falls below 42°F (5°C), to prevent it from freezing, at minimum energy consumption. The display will show "LO" (see figure). This function is not guaranteed in the event of black outs, even if lasting just a few seconds. * AM MAN 5 GB 10-05-2001 9:00 Pagina 6 4) PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period to programme the timer. Press the button " AUTO" (fig. 2), this accesses the 1st programme (programme A). [. . . ] Call the nearest Service Center (see attached list of Service Centers). ATTENTION A safety device switches the fan heater off if it accidentally overheats. An audible signal warns of any problems. To reset the unit for normal operation, remove the plug from the mains socket for a few minutes, eliminate the cause of overheating (e. g. air intake or outlet grilles obstructed) and then plug the fan heater back in again. [. . . ]