User manual DELONGHI DFH550R

[. . . ] Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. To disconnect the appliance, turn controls to off, then remove plug from outlet. Connect to properly polarized outlets only. [. . . ] Never obstruct the intake and outlet grilles (danger of overheating). - The appliance must be installed so that the switches and other controls cannot be reached from a person standing in a bathtub or a shower. - The electrical feed cord must be replaced only by officially authorised personnel. ELECTRIC POWER CONNECTION The fan heater must be connected to a properly polarized A/C 110/120 V household outlet in perfect working condition. Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater is plugged in. INSTALLATION The fan heater can be easily positioned on any horizontal support surface in an upright position. FAN HEATER CONTROLS:The thermostat will adjust the set temperature automatically and keep it constant. thermostat dial ventilation only These two LEDs indicate the selected power level Fig. 1 ON/OFF button 4 As the appliance cycles between the different power levels when it is in use, these two LEDs indicate the level currently in use OPERATION AND USE By pressing the "ON/OFF" button (Fig. 1) one or more times (a beep will confirm each selection), the appliance will select the operating heating power, as follow: P max (maximum power) P med (medium power) P min (minimum power) Fan only (summer operation) off If "P max" maximum appliance operating power has been selected, adjust the thermostat dial (Fig. 1) to the desired comfort temperature, from 42°F and 95°F (5°C and 35°C). °C 5 10 15 20 25 30 35 °F 41 50 59 68 77 86 95 room temperature If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heating the room until it reaches the selected temperature. The unit will automatically mantain the temperature at a constant level, by cycling between "max" (fig. 2), "med" and "min", as it approaches the selected comfort temperature. If the room temperature exceeds the selected temperature level, the appliance will turn itself off. 5 Selected power Power used MAX MAX MAX MED MAX MIN MAX OFF fig. 2 The appliance will turn on automatically again when the room temperature falls below the selected temperature level. If a power level below "P max" has been selected using the "ON/OFF" button, the appliance will modulate between the selected level and the lower power levels. ANTIFREEZE FUNCTION Press the "ON/OFF" button to select the "P max" power level. Set the thermostat dial to the " " position (Fig. When set in this way, the appliance will turn on automatically only if the room temperature falls below 42°F (5°C), to prevent it from freezing at minimum energy consumption. This function is not guaranteed in the event of black outs, even if lasting just a few seconds. * MODELS WITH ROTATING BODY This appliance is fitted with a motorized base and a rotating body. To distribute the air flow over a larger area, push the foot switch (Fig. When activated, the appliance will oscillate from right to left over an angle. To stop the appliance in the desired position, simply push the foot switch again (a beep will confirm the selection) Fig. 3 MODELS WITH REMOTE CONTROL Some models are equipped with a remote control to provide ease of operation. The appliance can be completely controlled with the remote control. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. If repairs become necessary or spare parts are needed, please write to: DE' LONGHI AMERICA INC. Park 80 West Plaza One, 4th floor Saddle Brook, NJ 07663 or call Service Tel. 1-800-322-3848 or visit our internet site www. delonghi. com The above warranty is in lieu of all other express warranties and representations. [. . . ]