User manual DELONGHI DS 105

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on typer, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be based until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ] the canister is missing put the canister back into position 3. the canister is badly positioned position it correctly 4. you are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill" remove the blockage. Once the cause has been removed, the warning lamp goes off and the appliance starts working again. 13 Electrical connections Before connecting the appliance to the power supply, check the following: · The mains power supply must correspond to the power supply shown on the rating plate. · The power socket and the electrical circuit must be adequate to supply the appliance. · The power socket must match the plug. If not, have the plug replaced by qualified personnel. · The power socket must be adequately earthed. The manufacturer accepts no responsibility if these safety regulations are not complied with. This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of radio interference. Description of the controls Humidistat knob Canister control system pilot lamp Using the dehumidifier 1) Plug the appliance into the power socket. The pilot lamp lights to show that the appliance is plugged in. 2) Check that the "Canister control system" pilot lamp is off. 3) Turn the humidistat knob to "CONTINUOUS" for continuous operation. 4) To switch off the appliance, turn the humidistat knob anti-clockwise to the "OFF" position. Note: For technical reasons, the humidity is expressed in levels rather than in degrees. We recommend starting with the humidistat knob set to "CONTINUOUS". When the humidity in the room reaches the desired level, turn the knob slowly anti-clockwise until the appliance switches off. In this way, the appliance is programmed to maintain the exact humidity level that you desire. When in its dehumidifying function the appliance not only dehumidifies but also heats the room slightly. The following use examples are given on the equipment's control panel: 14 To dehumidify an area that is not lived in, such as a cellar. To dehumidify rooms where low humidity is desired, such as the laundry room. Maintenance Always remove the plug from the power socket before performing any cleaning or maintenance operations. For safety, never use a jet of water to wash the appliance. Cleaning the cabinet · Clean the appliance using a damp cloth and dry using a dry cloth. · Never use petrol, methylated spirits or solvents to clean the appliance. [. . . ] · Do not move the appliance by pulling the power cable. · Do not install the appliance in areas containing gas, oil or sulphur. Do not install the appliance near sources of heat. · Do not place heavy or hot objects on the top of the appliance. [. . . ]