User manual DELONGHI EAM 2000 CAFFE VENEZIA

[. . . ] 21 1 2 3 4 Description of the appliance Safety warning Installation . . . . . . 24 4. 2 Filling the container with coffee beans 4. 3 Using the coffee maker for the first time 5 6 7 8 9 Preparing the coffee (using coffee beans) Adjusting the coffee grinder . . . . . . 26 Preparing espresso coffee with ground coffee (instead of beans) . . . . . . 28 Preparing cappuccinos (using steam) 10 Cleaning and maintenance . . . [. . . ] · Prepare the espresso coffee as described in the previous paragraph, using sufficiently large cups. · Then press the steam button (Fig. 22) starts flashing to indicate that the machine is heating up. · When the light remains on steady and stops flashing, the temperature of the machine has reached the ideal value for making the steam (par. · Immediately after, within a maximum of two minutes (otherwise the machine automatically returns to the coffee function), dip the milk frother into the container of milk (Fig. 23), making sure not to immerse the line in relief on the milk frother (indicated by the arrow in Fig. 24) and turn the steam knob half a turn anticlockwise until it stops (Fig. The steam released will make the milk froth and increase in volume. To make creamier foam, dip the milk frother into the milk and rotate the container with slow movements from the bottom to the top (you are recommended to limit steam delivery to no more than two minutes at a time). · Once having reached the desired temperature, stop the steam by turning the steam knob clockwise until it stops (Fig. 6) and then press the steam button (Fig. · Pour the frothed milk into the cups containing the espresso coffee prepared previously. The cappuccino is now ready (add sugar to taste and if desired, sprinkle the foam with a little cocoa powder). NOTE 1: : immediately after having prepared the cappuccino, once having pressed the steam button Fig. 21) to deactivate the function, when pressing the (Fig. 13) to make coffee again, the machine is too hot to make coffee (the green and lights flash to indicate that the temperature is not suitable); simply wait around ten minutes for the machine to cool down a little. HINT: To cool it down more quickly, after having deactivated the steam function, open the steam knob and release some water from the milk frother into a container, until the green and lights stop flashing. NOTE 2: The milk frother must always be cleaned after use. Proceed as follows: · Release a little steam for a few seconds by turning the steam knob anticlockwise until it stops (Fig. 5). GB Fig. 21 Fig. 22 Fig. 23 Fig. 24 OPERATING INSTRUCTIONS 30 · With this operation, the steam spout discharges any milk that may be left inside. IMPORTANT: For reasons of hygiene, this operation should always be performed, so as to prevent the milk from remaining in the circuits inside the milk frother. Turn the knob clockwise as far as it will go. [. . . ] 6). · · The coffee comes out too slowly · The ground coffee is not correct Use another brand of coffee blend. 6). · The machine uses too much cof- Turn the right-hand knob (Fig. 7) a little antifee during the infusion process clockwise. The coffee is ground too coarse The machine uses too little coffee during infusion. [. . . ]