User manual DELONGHI EC 9

[. . . ] · Never allow the appliance to be used without supervision by children or incapable persons. · Make sure that children do not play with the appliance. · In the event of failure or malfunction, switch off the appliance and do not tamper with it in any way. If the appliance requires repair, contact an authorised technical service centre only and ask for original spare parts to be used. [. . . ] To attach the filter holder to the appliance, hold it under the boiler outlet (fig. Push the filter holder upwards and at the same time rotate it towards the right as far as it will go. Make sure the filter holder is firmly in place, the position of the filter holder handle with respect to the appliance is irrelevant. 7 The jug must be positioned under the filter holder in such a way that the spout of the filter holder is inside the opening in the cover of the jug (fig. 7). 8 Position the selector (A) to the type of coffee you want to obtain: "LIGHT" for light coffee, "MEDIUM" for normal coffee, "STRONG" for strong coffee (fig. 8). 9 Make sure the steam knob (F) is fully closed and press the luminous switch. 10 It takes about three minutes for coffee delivery to begin. After the coffee has been delivered, turn the luminous switch off. IMPORTANT: To avoid discharge of steam, before removing the filter holder, always vent all steam FITTING THE ADAPTER To make coffee directly in the cup, the adapter (R) must be used. To fit, simply insert it in the bottom part of the filter holder (fig. 12). PREPARING CAPPUCCINO COFFEES · Pour the quantity of milk required to make the cappuccino coffees (about 100 cc for each cappuccino) into the milk tank (E) (fig. Never exceed the MAX level (corresponding to about 250 cc) marked on the tank (fig. 14) otherwise milk may continue to drip from the milk tank tube after frothing has been completed. When preparing four cappuccino coffees, the milk in the tank must be topped up. · Prepare the coffee as described in the paragraph "PREPARING THE COFFEE" from point 1 to point 8, but using more water as specified in the table at the end of the manual. · Turn the appliance on by pressing the luminous switch. When the coffee reaches either the 2 or 4 level indicated on the jug, stop delivery of the coffee by placing the coffee selector in the "CAPPUCCINO" position. IMPORTANT: The 2 or 4 mark should correspond not to the level of the light coloured cream, but to the darker coloured coffee under the cream. Great care must be taken during this operation. If the level of coffee exceeds the 2 or 4 line, there will not be sufficient steam to froth the milk. · One at a time, place the cups containing the coffee under the milk tank tube (fig. 15) and wait 11 until the steam ready light (I) comes on. When using small cups, to avoid splashes of milk, fit the splash hood (G) onto the milk tube (fig. [. . . ] Proceed as follows: · Remove the milk tank by pressing the "PRESS" lever and at the same time pulling upwards. · Remove the red emulsifier by pressing on the clip (A) and at the same time pulling upwards (fig. Remove the rubber mixer, wash and clean with hot water (fig. 19), particularly the four holes indicated in figure 20 (use a needle). [. . . ]