User manual DELONGHI EC7

[. . . ] · Check that the voltage corresponds to that indicated on the appliance rating plate. The appliance must always be connected to a well-earthed socket rated at 10A minimum. The manufacturer is not liable for damage caused by inadequate earthing of the appliance. · In the event of incompatibility between the plug on the appliance and the socket, have the plug replaced by a qualified professional. If the cable is damaged or requires replacing, contact a service centre authorised by the manufacturer only. · Never install the machine in an environment that can reach a temperature less than or equal to 0°C (if the water in it freezes, the coffee maker may be damaged). 3 Coffee Maker How to prepare espresso coffee Filling the water tank Remove the tank by pulling sideways and lifting the intake tubes out of the water (fig. [. . . ] NB: YOU ARE RECOMMENDED TO USE SEMI-SKIMMED MILK AT REFRIGERATOR TEMPERATURE. Place the container with the milk under the cappuccino maker. Dip the cappuccino maker into the milk (fig. 19), taking care not to immerse the raised line on the cappuccino maker (indicated by the arrow in fig. 20). Turn the steam knob at least a half turn anticlockwise (fig. Steam is given off by the cappuccino maker, giving the milk a creamy frothy appearance. To obtain a creamier froth, dip the cappuccino maker into the milk and rotate the container with slow movements from the bottom upwards. When the required temperature is reached, interrupt steam delivery by rotating the steam knob clockwise. Pour the frothed milk into the cups containing the espresso coffee. Your cappuccino is now ready. If desired, add sugar and sprinkle a little powdered chocolate or cinnamon on top of the froth. Note: to prepare more than one cappuccino, first make all the coffees then at the end prepare the frothed milk for all the cappuccinos. · Remove the crema enhancer from the container by pushing it from the cap end (fig. · Rinse all components and clean the metal filter thoroughly in hot water using a brush (fig. Make sure the holes in the metal filter are not blocked. If necessary, clean with a pin (see fig. 30) or, preferably, by burning the particles obstructing the holes over a flame (TAKE CARE TO AVOID BURNS). · Replace the filter and gasket on the plastic disk as shown in fig. Make sure to insert the pin on the plastic disk into the hole in the gasket indicated by the arrow in fig. · Replace the assembly in the steel filter container (fig. 32), making sure the pin is inserted in the hole in the support (see arrow in fig. Failure to clean as described above invalidates the guarantee. fig. 34 Cleaning the pod filter holder (if fitted) About every 200 coffees, clean the pod filter holder as follows: · Push the filter holder button and remove the filter (fig. [. . . ] · The manufacturer takes no responsibility for damage derived from improper use. · Never touch the appliance with wet or damp hands. · Never allow the appliance to be used by children or unfit persons. · In case of breakdown or malfunctioning, turn the appliance off immediately and do not touch. [. . . ]