User manual DELONGHI ECC 2400T

[. . . ] Check that no pieces of polystyrene or other packaging material have been left between the elements of the heater. ELECTRICAL CONNECTION - Before plugging the radiator into the mains, check that your supply voltage is the same as that shown on the rating plate of the appliance. - If using more than one appliance at a time, it is important to ensure that the ring main is adequate to cope with the power requirements. - It is important to ensure that the socket is adequately earthed. [. . . ] If medium power level has been selected using the "ON MODE" button, the appliance will 4 5710004200 hm uk 31-01-2002 14:43 Pagina 5 modulate between medium, minimum power and OFF to maintain a selected temperature. Note: the display will always show the power setting you have chosen, not the one it is currently working at. FROST STAT FUNCTION Press the "ON MODE" button (it is recommended to select the maximum power level). Set the temperature to 5°C with the " -" button. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, thereby preventing freezing, at minimum energy consumption. N. B. This function is not guaranteed in the event of power failures, lasting more than 2 minutes. MAN : °C 3) PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period. To programme the timer: 1-Press the " AUTO" button, this accesses the 1st programme (programme A). The yellow timer ON lamp will light up. AUTO : °C Timer lamp on 2-Set the start time for your programme by pressing the "HOUR" button to set the hour and the "MIN" button to set the minutes. 3-To select how long you require the heater to be on, push the "+min" button repeatedly until your chosen operating timespan appears. The time periods you are able to choose from are (30', 45', 1hr, 2hr, 4hr, 8hr (max). AUTO AUTO AUTO °C : O O : 0 Display when setting programme A Display when setting programme B Display when setting for 45 mins operating time 4- To program a second time period (programme B), press the " AUTO" button twice and then proceed as above to select the start hours and minutes. The set time will be the same as for the first programme. When the operating time is changed, the time of both programmes is updated. Important: the operating time period must be the same as in Programme A. to 1hour, both programmes will operate for 1 hour. 5 5710004200 hm uk 31-01-2002 14:43 Pagina 6 5- Use the " +" or " -" buttons to set the desired comfort temperature, as described above. 6-When set in this way the heater will automatically switch on at the set time for the designated time period and automatically maintain the preset comfort temperature. To cancel a programme, press the " AUTO" button and then the "hour" buttons until the display shows as below. : AUTO TIMER OVERRIDE To operate the appliance without using the timer, press the "ON MODE" button (Fig. 3). To go back to timed operation press " AUTO". IMPORTANT You must leave the heater plugged in at the mains socket to keep the heater's memory programmed. If the heater loses its electricity supply for more than 2 minutes, e. g. if unplugged or in the event of a power failure, the heater's programmes will be lost, and the timer will not work until reset. In such an instance the display will show flashing numbers. On using the appliance for the first time, turn it on to the maximum power and the highest temperature setting for at least 8 hours. [. . . ] - It is normal for the appliance to emit a squeaking noise when turned on for the first time. - The heater must not be located directly below a socket-outlet. - The appliance is not intended for use by young children or the infirm without supervision. - Young children should be supervised to ensure that they do not play with the appliance. [. . . ]