User manual DELONGHI ELECTRIC CONVECTOR HEATER HCO

[. . . ] - It is important to ensure that the socket is adequately earthed. - This appliance complies with EEC Directive 89/336 relating to electromagnetic compatibility. How to use it To fit the feet, proceed as follows: Insert the foot into the guide on the side and push as far as it will go until the two teeth hook in place (fig. Wall mounting IMPORTANT: Before drilling into any wall ensure no electrical cables are present in the area. [. . . ] · Turn the selector to the Max position to select maximum power (the Max power light comes on). Adjusting the thermostat When the room has reached the required temperature, turn the thermostat dial (B) slowly anticlockwise until the lights go out and no further. The thermostat will automatically regulate the temperature set and keep it constant. In spring or autumn or on mild days, you can save energy by using minimum power. Frost prevention mode With the thermostat dial in the position and one of the power levels selected, the appliance maintains room temperature at about 5°C, preventing freezing with minimal energy consumption. Models with fan A number of models have a fan for faster more even heating. To use this function, turn the power selector (A) to the Max position (the corresponding light comes on). 21 20 Using the timer(C) To set the heating periods proceed as follows: 19 16 pointer Fig. 5 Setting the correct time Check the time on your watch. (16. 00), turn the dial in a clockwise direction until the number 16 is lined up with the triangular pointer (fig. 5). N. B. : Never turn the dial in an anti-clockwise direction!The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the clock must be re-set. To program the timer 1) Set the operating times by pushing in the notches on the dial corresponding to the period required (each notch represents 15 mins. ) (fig. 6). 2) Make sure that the timer indicates the correct time (see instructions on setting the correct time). Once programmed in this way, the appliance will repeat the pre-estab- operating time 21 20 19 16 Fig. 6 lished program every day. Electric convector heater 4 Maintenance Always unplug from the mains socket before cleaning. The convector heater requires no special maintenance. It is sufficient to remove dust with a soft dry cloth. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Only use the heater in an upright position. - The heater must be positioned at least 50cm from walls, curtains, furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. - Do not use this appliance in rooms which have a floor area smaller than 4m2 as this may lead to overheating. - The heater must never be placed immediately under a fixed mains socket. - Never obstruct the heaters intake and outlet grilles as this could cause dangerous overheating. [. . . ] As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin. Electric con- Electrical connection (U. K. only) A) Your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING:Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. [. . . ]