User manual DELONGHI ELECTRIC DEEP FRYER F457CZ

[. . . ] The brown wire must be connected to the terminal marked with the letter L or coloured red. 2 I-GB-F-D-NL-E-P-GR 26-09-2003 15:54 Pagina 3 fig. 6 60° I O MIN 140° 160° 180° NO! fig. 8 3 I-GB-F-D-NL-E-P-GR 26-09-2003 15:54 Pagina 9 GB READ THIS INSTRUCTION BOOKLET CAREFULLY BEFORE INSTALLING AND USING THE APPLIANCE. [. . . ] Check that water does not enter into the control unit and that there is no residual water in the bottom of the removable bowl. Check that the control unit is properly fastened to the deep fryer body. The safety micro-switch "C" will not allow the appliance to be operated if the control unit "Z" is not correctly positioned in the casing "L". The deep fryer is now ready for use. SETTING THE TIMER (if featured) Press the button "G"; the display will show "OO". Keep the button "G" pressed until the required time is shown on the display. The set time can range from 01 to 99 minutes. Once the required time has been set, release the button "G". The display will start counting down: · from 99 to 01 minutes, the display will count down minute by minute; · from 01 minutes on, the countdown will be in seconds. An audible signal will indicate the end of the set time; to switch off the audible signal, simply press the timer button "G". To change the setting of the timer, reset it by holding the button "G" for a number of seconds. The timer signals the end of the set time, but does not stop the appliance. To replace the battery, access the inside of the casing "L", proceeding as follows: · Remove all the deep fryer components; · Unscrew the two screws that support the timer; · Remove the timer being careful not to let go of the button; · Turn the battery cover in an anticlockwise direction until it is released. · Replace the battery with another of the same type; To re-insert the timer, perform the same operations in reverse. When either replacing or disposing of the appliance, the battery must be removed and disposed according to the laws in force, in that it may damage the environment. FILLING WITH OIL OR FAT · Remove the cover "O" by lifting it by the handle. Turn the folding handle of the basket until it locks into place (pos. Remove the basket "Q" by lifting it upwards. · Remove the length of cable required to connect the appliance to the mains, from the cable compartment "S" (see Fig. · If oil is used, pour it into the bowl "P" until reaching the maximum level indicated (see Fig. Never exceed this limit, as oil may overflow from the container. The level of oil must always be between the maximum and minimum limits, "D" (max. For best results, use good quality peanut oil. · If lumps of fat are used, cut the lumps into pieces and melt them in another container, then pour the liquefied fat into the deep fryer bowl. [. . . ] When this procedure has been completed, carefully dry all parts, to prevent hot oil from spraying out during operation. OPERATING FAULTS FAULT Bad smell CAUSE The oil has deteriorated. The cooking liquid is unsuitable. REMEDY Replace the oil or fat. Use a good quality sunflower or vegetable oil oil. Reduce the amount of oil in the fryer bowl. [. . . ]