User manual DELONGHI ELECTRIC HEATING CONVECTOR HCA530FTS

[. . . ] This bracket when fixed retains the base of the convector in a fixed position, preventing removal. Remove the convector heater from the hanging brackets and drill the wall for 2 x suitable wall plugs and insert them. Fit the convector to the 2 brackets "A". Insert Brackets "B" to the convector base and fix brackets "B" to the wall plugs by means of 2 x No 8 screws ( minimum length 25 mm). [. . . ] Important: when the heater has been set for timed operation and is in a standby period (i. e waiting to come on), the LEDs on the right hand side will light up and go out intermittently. 5) one or more times, to select your ope- The LEDs on the left hand side show you the power selected A Press once Maximum power Fig. 5 Button B Press twice Medium power C Press three times Minimum power D Press four times OFF If maximum power has been selected, adjust the thermostat dial (fig. 6) to the desired comfort temperature from (5°C) and MAX (35°C). If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected temperature. The unit will automatically maintain the temperature at a constant level by cycling between max power, med power and min power as it approaches the selected comfort temperature (see fig. 6 Display LEDs Selected power Power used MAX MED MAX MIN OFF Cycles between If the room temperature exceeds the selected temperature level, the appliance will switch off (fig. The heater will switch back on automatically when the room temperature falls below the selected temperature level. If medium power level has been selected using the button, and the thermostat set, the heater will modulate between the medium and minimum power levels. As with the maximum power setting, if the room temperature exceeds the selected temperature, the appliance will switch off, and then on again when the temperature falls. (For models with timer, ensure that the switch on the timer dial (fig. 4) is in position 1, manual. NOTE: if the timer switch is at the 0 position (fig. 4), the heater is off and will not operate). 4 5713003700 11-06-2002 14:03 Pagina 5 Frost stat function Press the button, it is recommended to select maximum power level. Set the thermostat dial to the " " position (fig. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent freezing, at minimum energy consumption. This function is not guaranteed in the event of power failures, even if lasting just a few seconds. * Models with turbo fan boost (see fig. 1) A number of models have a turbo fan boost for even more rapid and uniform heating. To use this function, press the switch on the fan grill. Cool air ventilation To operate the fan only for "cool air" ventilation, ensure that ECC is off and turn the thermostat to the maximum then press the switch on the fan grill. USING THE TIMER If you wish to use the timer, position the switch in the middle position . The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the clock must be re-set. TO PROGRAM THE TIMER 1) Set the operating times by pushing out the notches on the dial corresponding to the period required (each notch represents 15 mins. ) 2) Make sure that the timer indicates the correct time (see instructions on setting the correct time). [. . . ] - Do not use this appliance in rooms which have an area smaller than 4m2. We recommend that you do not place the heater in a draught, because strong draughts of air may adversely affect the equipment's operational efficiency. - The heater must never be placed immediately under a fixed mains socket. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. [. . . ]