User manual DELONGHI ELECTRIC HEATING CONVECTOR HS

[. . . ] This bracket when fixed retains the base of the convector in a fixed position, preventing removal. Remove the convector heater from the hanging brackets and drill the wall for the dowels and insert them. Fit the convector to the 2 brackets "A". [. . . ] If your convector has two switches press one or both switches on. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent freezing at minimum energy consumption. Model with a fan This version makes it possible to heat a room even more quickly, thanks to a built-in fan that speeds up the spread of heat and keeps the temperature uniform. To turn this unit on, proceed as follows: · Turn the thermostat knob clockwise to the last possible setting. · To operate the appliance at minimum without the fan, press the button of the left switch (the red area will become visible). · To operate the appliance at minimum with the fan, press the button of the right switch (the red area will become visible). · Push both switches in order to get the highest power In this model, the thermostat can be adjusted just as it is for models without a fan. 4 HS Cleaning and maintenance The convector should not require any maintenance. However before carrying out any cleaning or maintenance, unplug the heater from the mains and wait for it to cool (this should take around 5 minutes. It is sufficient to remove external dust with a soft, dry cloth. If necessary, remove concentrated areas of dirt with a vacuum cleaner. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Never place the power cable on top of the heater while it is hot. - Only use the heater in an upright position. - Do not block the outlet grilles at the top of the heater or the intake grille at the botton of the heater. - The heater must be positioned at least 50cm from furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. - Do not use this appliance in rooms which have a floor area smaller than 4m2. - We recommend that you do not place the heater in a draught as this may adversely affect the appliance's operational efficiency. [. . . ] WARNING:Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. [. . . ]