User manual DELONGHI ELECTRIC SUPER PANEL HEATER

[. . . ] Check that neither the heater nor the power cable has been damaged during transport. Do not operate the heater if damaged. Your heater is suitable for either freestanding or wall mounting usage. Do not assemble the feet if wall mounting. Free standing operation To fit the feet to the appliance, proceed as follows: Slide the foot's tab on the slot provided on the back of the heater then fix the foot with the relevant screw, as shown in fig. 2. Fig. 2 Installation wall-mounting The wall mounting kit should contain: 2 x Upper brackets (X) 2 x Lower brackets (Y) 4 x Screws (4, 5 x 25) 4 x Wall plugs ( ø 6 x 30) 2 x Feet screws (3, 5 x 9, 5) (for freestanding operation) 1. [. . . ] For other wall types please seek specialist advice). Mount the wall bracket "X" in the "F" holes using the screws provided. Position the lower brackets (Y) into the tabs located in the base of the heater. Move the bracket up until it is horizontal and then fix them with the screws provided. 3 2 (Y) 1 Fig. 3 Electric Super Panel Heater INSTRUCTIONS FOR USE Switching on Plug into the mains socket. Switch the appliance on using the switch/switches following the procedures given: - switch «Eco» = minimum power (indicator light on); - switch «Med» = intermediate power (indicator light on); - both switchess «Eco» «Med» = Max (indicator lights on) To turn appliance off, switch off both switches or remove plug from wall socket. Maintenance Before carrying out any maintenance, unplug the heater from the mains and wait for it to cool. The heater requires no particular maintenance. It is sufficient to remove the dust with a soft, dry cloth. If necessary remove concentrated areas of dirt with a vacuum cleaner. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools. - Never place the power cable on top of the heater while it is hot. - Only use the heater in an upright position. - Do not block the hot-air outlet grilles or the intake grille. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. We recommend that you not place the heater in a draught, because strong draughts of air may adversely affect the equipment's operational efficiency. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. - The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the heater. - This appliance is filled with a precise quantity of oil and repairs which require it to be opened must be carried out exclusively by the manufacturer or an authorised service centre. In the case of oil leaks, contact the manufacturer or the authorised service centre. [. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be refitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ]