User manual DELONGHI EW6507

[. . . ] This heater becomes very hot when operating. To avoid burns, do not touch its hot surfaces with your bare skin. Use the heater's handle when moving it. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (90 cm) away from the heater's front and top, and also well away from its sides and rear. [. . . ] When switching the heater on for the first time, allow it to run at full power for about two hours to get rid of a possibly unpleasant smell. Make sure that the room where the heater is placed is well ventilated during this first operation. Soft crackling sounds are normal during the heater's first operation. the appliance is located is well ventilated during this operation. It is normal for the appliance to emit small cracking sounds when you turn it on for the first time. CAUTION: To prevent electric shock match wide blade of plug to wide slot, fully insert. SAVE THESE INSTRUCTIONS 2 GB-E 13-01-2004 14:26 Pagina 3 HOW TO USE YOUR HEATER FITTING THE WHEELS Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Fully unfold the castors by turning them outwards (Fig. Turn the radiator back to its upright position. fig. 1 BE CAREFUL Operate the heater in upright position only (wheels on the bottom, controls on the top). Any other position could create hazard situation!WATTS ECONOMIZER For more economical use, the Min. Watt switches may be used individually, after unit has reached the operating temperature. ON/OFF Switches Pilot lights 800 700 WATTS WATTS BOTH 1500 WATTS With pilot lights ON, the heater is ON! 1. LOCATION Place heater on the floor beneath the coldest window in the room, or any other location. Your heater will reduce the effect of cold drafts. The heater should not be placed immediately below a power outlet. Do not use this radiator in rooms with a floor area of less than 43 square feet (4 sq. CONNECTION The radiator should be connected to a properly polarized A/C 110/120 V household outlet in perfect working conditions. Keep loose clothing or bedding, furniture and flammable material away from the heater's wall outlet. TURNING ON TWO-SWITCH MODELS Turn the thermostat clockwise to its maximum position. The switch lights stay on independently of the thermostat cycling. When room reaches the desired temperature, turn the thermostat knob counter-clockwise very slowly and carefully until you hear a click. This should set your heater to maintain the desired temperature by cycling on and off as required. (For timer instructions, see paragraph 5. ) Note: The heater normally requires about 15 minutes to reach the desired temperature. 3 GB-E 13-01-2004 14:26 Pagina 4 4. USE OF THERMOSTAT The thermostat operates according to room air temperature, rather than radiator temperature. [. . . ] This appliance has been built to last for many years of trouble-free service. In case of malfunction or doubt, do not try to repair the heater by yourself: this might increase the risk of fire and electric shock. Call your nearest Service Center (see attached list of Service Centers). 5 GB-E 13-01-2004 14:26 Pagina 6 LIMITED WARRANTY What Does This Warranty Cover?We warrant each appliance to be free from defects in material and workmanship. [. . . ]