User manual DELONGHI FAN HEATER HBP552-3B

[. . . ] - When you plug in the appliance, the red pilot light will illuminate (Fig. INSTALLATION The appliance requires no installation; it should be used solely as a portable appliance on an horizontal surface. Portable appliances are not suitable for use in a bathroom. OPERATION AND USE 1) SETTING THE CLOCK For the first time, set the clock to the correct time, proceeding as follows: · Press the "hour" button until the display shows the hours for the correct time, then release the button (fig. 1). · Press the "min" button until the display shows the minutes for the correct time, then release the button (fig. [. . . ] The display will show 5°C (see figure below). When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, thereby preventing freezing at minimum energy consumption. If the temperature in the room falls below 5 °C the room temperature display will show "LO". This function is not guaranteed in the event of power failures, lasting more than 2 minutes. MAN °C * PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period. Press the button " AUTO" (fig. 2), this accesses the 1st programme (programme A). TIMER ON yellow lamp AUTO MAN °C O fig. 2 2. Set the start time for your programme by pressing the "hour button" to set the hour and the "min" button to set the minutes. To select how long you require the heater to be on, push button " " and repeatedly until your chosen operating timespan appears. The time periods you are able to choose from are (15', 30', 45', 1hr, 2hr, 4hr (max)). AUTO AUTO AUTO °C : O O : Display when setting Programme B Display when setting Programme A Display when setting for 45 min operating time 4. To programme a second time period (programme B) press the " AUTO" button twice and proceed as above. (Note: The operating period must be the same as in programme A, if the operating time is changed eg. from 45 mins to 1hr, both programmes will operate for 1 hr). Now set the comfort temperature as previously described by using the thermostat dial. The power level will automatically be set to maximum and will reduce to the lower power levels as required. The heater will switch on automatically every day at the preset time for the designated time period and will automatically maintain the selected confort temperature. If you wish to cancel a programme press the " AUTO" button and then 5 5714005700 HBP552. 3 30-10-2001 12:21 Pagina 6 the "hour" and "min" buttons until the display shows: : O Time Override If you wish to operate the heater without timer, press the "MANUAL FUNCTION" button. The yellow timer pilot light will go off. To go back to timed operation press auto. IMPORTANT You must leave the heater plugged in and switched on at the mains socket to keep the heaters memory programmed. [. . . ] - If the power cable is damaged, it must be replaced by the manufactured or an authorized technical service centre. - The appliance must not be positioned directly underneath a fixed power point. - Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire. - Do not use the appliance in rooms less than 4 m2 in area. [. . . ]