User manual DELONGHI FAN HEATER HVE332-3

[. . . ] WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit IMPORTANT The wires in the mains lead are coloured in accordance with the followin code: Blue: Neutral Brown: Live must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] Heating at full power: turn the knob (left) to setting 2. Switching off: turn the knob (left) to setting 0. Models with switches and or ambient thermostat (where included) Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum setting. Heating at reduced power: press a single switch (the red area is visible on the switch) Heating at full power: press both the switches (the red area is visible on the switch) Summer service (ventilation only): Turn the thermostat knob (right) in an clockwise direction until it reaches the maximum setting, pressing both switches (in the off position). Switching off: turn off the switches and turn the thermostat knob (right) in an anti-clockwise direction until it reaches the minimum setting. It is always advisable to disconnect the plug when the appliance is not in use. Models with thermostat only The appliance is switched on by turning the knob in a clockwise direction until it reaches the maximum setting; to switch the appliance off turn the knob to the minimum setting and remove the plug from the electrical socket. REGULATING THE THERMOSTAT When the room has reached the required temperature turn the right thermostat knob (where included) in an anti-clockwise direction up to the point where the appliance switches off and not beyond. The temperature fixed in this way will be automatically regulated and kept at a constant level by the thermostat. ANTIFREEZE SERVICE Turn the left knob to setting 2, or use the switches so that the red area appears, then turn the right thermostat knob to setting . When it is set in this way the appliance keeps the room at a temperature of approx. 5° C with minimal energy expenditure. CLEANING AND MAINTENANCE Before cleaning always remove the plug from the electrical socket. Clean the air inlet/outlet grilles frequently. WARNINGS Do not use the appliance in bathrooms or in the vicinity of showers, bath tubs, wash basins, swimming pools, etc. Always use the heater in an upright position. [. . . ] Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire. Do not use the appliance in rooms less than 4 m2 in area. The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg. [. . . ]