User manual DELONGHI FAN HEATER RCH100

[. . . ] instr uctions CERAMIC FAN HEATER RCH100 Please retain these instructions for future reference Switch Thermostat knob Display Pilot lamp Ceramic fan heater 2 Thank you for choosing this ceramic fan heater. To get the very best out of your new ceramic fan heater it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety. General instructions Remove the heater from the packaging. [. . . ] The thermostat will then keep room temperature at the selected level automatically. Frost protection function Turn the thermostat knob fully anti-clockwise so the is positioned a the pointer. Select a heat setting using the function selector (position I or II). When set in this way, the ceramic fan heater will switch on automatically only if the room temperature falls below 5°C to prevent freezing at minimum energy consumption. 3 Ceramic fan heater Maintenance - Always unplug from the mains socket before cleaning. - During the season when the appliance is in use, clean the air intake and outlet grilles regularly using a vacuum cleaner. - Never use abrasive powders or solvents. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Only use the heater in an upright position. - The heater must be positioned at least 50cm from walls, curtains, furniture or other objects. - If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. - Do not use this appliance in rooms which have a floor area smaller than 4m2 as this may lead to overheating. - The heater must never be placed immediately under a fixed mains socket. - Never obstruct the heaters intake and outlet grilles as this could cause dangerous overheating. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. - A safety device intervenes and turns the appliance off in the event of overheating. To reactivate the heater, remove the plug from the mains, allow the appliance to cool (for about 30 minutes), remove the cause of the overheating and then plug the appliance back into the mains and turn it back on. - The use of an extension lead is not recommended, as overheating of the extension lead may occur during the operation of the heater - In order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. - As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children. [. . . ] In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below: important The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. 5 Ceramic fan heater 417IDL/04. 05 [. . . ]