User manual DELONGHI FANS

[. . . ] INTRO +I 22-12-2004 17:36 Pagina 1 Ventilatori Fans Ventilateurs Ventilatoren Ventilatoren Ventiladores Ventilação ¡ªTMTM INTRO +I 22-12-2004 17:36 Pagina 3 8 10 9 7 6 5 4 3 1 11 13 12 2 14 15 GB 5-04-2005 9:30 Pagina 6 GB Description/Assembly IMPORTANT Make sure your mains voltage corresponds to the voltage indicated on the rating plate. · Connect your fan to an efficiently earthed socket only. · Complete assembly before turning the appliance on. [. . . ] Note: To avoid the risk of fire or electric shock, never use the appliance with additional speed controls. DESCRIPTION 1) Front guard 2) Safety screw plus nut 3) Guard surround 4) Propeller 5) Propeller fixing screw 6) Screws 7) Rear guard 8) Handle 9) Motor unit + shaft 10) Swing control 11) ON/OFF/MIN/MED/MAX knob 12) Power cable 13) Tilt control 14) Base 15) Screws ASSEMBLING THE FAN · Assemble the fan as follows: · Remove the four screws and washers (15) from the base of the shaft (9), then attach the motor unit and shaft (9) to the fan base (14) using the four washers and screws (15). · Remove the four central screws (6) and washers from the motor unit (9). Attach the rear guard to the motor unit, centring it and fixing it with the screws removed previously. Note: When positioning the rear guard (7), make sure the handle (8) faces upwards. · Fit the propeller (4) with the screw (5) facing the motor unit. Lock the propeller in position using the fixing screw (5), making sure it corresponds to the flattened area of the motor shaft. · Position the front guard (1) near the rear guard (7) and fasten it using the surround (3), safety screw and nut (2). GB 5-04-2005 9:30 Pagina 7 Operation/Maintenance OPERATION · Plug the appliance into the mains. · Turn the ON/OFF knob (11) to the required position (Min/Med/Max). · To turn the appliance off, turn the ON/OFF knob (11) to "0". For "swing" operation, screw up the swing control (10) clockwise or unscrew it anticlockwise as required. To adjust the tilt of the fan, use the tilt control (13) on the top of the shaft. This should be done with the fan off only. MAINTENANCE · Always unplug the fan from the mains before cleaning or maintenance. · Never allow water to enter the fan controls. · We recommend you keep the packaging your fan came in. You can use it to neatly store the dismantled fan during the cold season. [. . . ] In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below: WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or [. . . ]