User manual DELONGHI FLA 49 ASRV

[. . . ] The manufacturer cannot be held responsible for possible inaccuracies due to printing or transcription errors in the present booklet. The manufacturer reserves the right to make all modifications to its products deemed necessary for manufacture or commercial reasons at any moment and without prior notice, without jeopardising the essential functional and safety characteristics of the appliances. Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. [. . . ] Turn the cooker top upside down and fasten the brackets "F and R" to the appropriate socket holes, without tightening the screws "B" for the moment. Make sure that the brackets are fastened as shown in figure 4. Spread the sealing material "D" out along the fixture hole, making sure that the junctions overlap at the corners. Insert the cooker top into the hole and position it correctly. Adjust the position of the brackets "F and R" and tighten screws "B" to block the cooker top firmly in position. With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the cooker top. Each cooker top is provided with an installation kit including brackets and screws for fastening the top to fixture panels from 2 to 4 cm thick. Turn the cooker top upside down and fasten the brackets "A" to the appropriate socket holes, without tightening the screws "B" for the moment. Make sure that the brackets are fastened as shown in figure 4. Spread the sealing material "C" out along the fixture hole, making sure that the junctions overlap at the corners. Insert the cooker top into the hole and position it correctly. Adjust the position of the brackets "A" and tighten screws "B" to block the cooker top firmly in position. With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the cooker top. It is recommended that a 30 mm clearance be left between the cooker top and the fixture surface (fig. The room where the gas appliance is to be installed must have a natural flow of air so that the gas can burn (in compliance with the current laws in force). The flow of air must come directly from one or more openings made in the outside walls with a free area of at least 100 cm2. If the appliance does not have a noflame safety device this opening must have an area of at least 200 cm2. The openings should be near the floor and preferably on the side opposite the exhaust for combustion products and must be so made that they cannot be blocked from either the outside or the outside. When these openings cannot be made, the necessary air can come from an adjacent room which is ventilated as required, as long as it is not a bedroom or a danger area (in compliance with the current laws in force). In this case, the kitchen door must allow the passage of the air. Extractor hoods connected directly to the outside must be provided, to allow the products of combustion of the gas appliance to be discharged (fig. If this is not possible, an electric fan may be used, attached to the external wall or the window; the fan should have a capacity to circulate air at an hourly rate of 3-5 times the total volume of the kitchen (fig. [. . . ] IMPORTANT: Installation must be carried out according to the manufacturer's instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility. Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains. Connection to the electric power supply must be carried out by a qualified technician and following the appropriate safety regulations. [. . . ]