User manual DELONGHI GC4000

[. . . ] · The appliance must be installed in line with the relevant national legislation. · Should repairs be necessary, contact the nearest authorised Repair Service Centre. Unauthorised servicing can be dangerous. · This appliance is to be used by adults only; keep away from children. [. . . ] ROOM TEMPERATURE buttons Set room temperature or programme the timer. ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the value shown in the specifications table; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug otherwise have the socket replaced; · the socket is properly grounded. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. 28 Warning lights/Forced operations THE LEDS Led displays come on depending on the selected function or as warning of possible anomalies. FUNZIONE OFF AIR-CONDITIONING DEHUMIDIFYING FAN SMART SUPER TIMER GREEN LIGHT on on - YELLOW LIGHT on BLU LIGHT on - As soon as this function is selected, all LED displays will remain on for some seconds until the control unit selects which mode to function in (whether air-conditioning, dehumidifier, fan or heater). - - on TIMER - if the TIMER mode is selected, the indicator lights remain on even when the appliance is off. ANOMALY ALARM* NO WATER IN TANK * Call the Service Centre GREEN LIGHT blinking YELLOW LIGHT blinking BLU LIGHT blinking on or off - blinking FORCED OPERATIONS This is a way of operating to be selected if there are problems with the remote control (broken or lost, or the batteries run-down). Press the button 3 until the required mode is selected (air conditioning, dehumidifying, fan, smart, off). Refer to the indicator lights and the table below to identify the mode selected. For each mode selected, the appliance will automatically choose the optimum values for maximum comfort. manual function button 29 ENGLISH Description of the remote control REMOTE CONTROL Inserting the batteries · Slide the cover as shown in figure. · Insert two new batteries (not rechargeable) making sure the (+) and (-) are in the correct positions. · Put the cover back on, letting it slide into its original position. · The Display will show all of the remote control's symbols for several seconds. Note: WE SUGGEST USING ALKALINE BATTERIES (LR03). If the remote control is to be replaced or thrown away, the batteries must be removed and disposed of in accordance with the current laws as it represents an environmental hazard. · The SUPER function will be deactivated automatically after 15 minutes PROGRAMMING THE TIMER After selecting the required operating mode, activate the timer by pressing the TIMER button when you go out in the morning to obtain a comfortable room temperature at the time you will be coming home. Programming the turn-off function · With the air-conditioning unit on, press the TIMER button. The time is displayed and the "h" symbol flashes. Set the time when you want the appliance to go off using the buttons (from 30 minutes to 24 hours). · Press the TIMER button again to confirm the selection. A countdown of the time left is displayed. · At the end of the set time the appliance goes off automatically. During the first ten hours, you can select half hour intervals. For times greater than ten hours, one hour intervals can be selected. · To cancel the set time, press the TIMER button again. Programming the ON function · With the air-conditioning unit off, press the TIMER button. [. . . ] To detach it, press on the two wings found on the side of the filter holder (see fig. G) Use a vacuum cleaner to remove the dust deposits on the filter. G immerse it in warm water, rinsing it thoroughly. The temperature of the water should be kept under 40°C. [. . . ]