User manual DELONGHI GM 6000

[. . . ] 5 If the power cable is damaged, it must be replaced by the manufacturer or the manufacturer's Custo mer Services in order to avoid all risk. 6 Never allow the appliance to be used by persons (including children) with psychological, physical or sensory impairments or with insufficient knowledge, unless closely supervised and instructed by someone responsible for their safety. Children must be supervised to ensure they do not play with the appliance. 7 After removing the packaging, make sure the appliance is not damaged. [. . . ] Important: you must never leave the appliance in this position for more than 1 minute. Leaving it in this position for longer could seriously damage the paddle rotation mechanism. Combined paddle rotation and chilling (compressor operating) This function to make the gelato through the combined action of the compressor and the paddle. When the gelato reaches the required texture, place the selector in the position to turn the appliance off. Normally each gelato making cycle lasts about30 - 40 minutes. Continuous functioning beyond this time will result in excessively hard gelato and serious damage to the paddle rotation mechanism. Important: if you need to work the ingredients with a whisk (e. , to froth the egg whites, beat the eggs and sugar, etc. ), you are recommended to prepare the ingredients in a separate container and then pour them into the bowl. INSTRUCTIONS ASSEMBLY AND DISSASSEMBLY The appliance comes assembled in the packaging but should be taken apart for cleaning before use. To take the appliance apart, remove the lid, then remove the paddle from the pin in the center of the bowl. Wash all parts thoroughly as described below in Cleaning section and then dry. To reassemble the appliance, insert the bowl and press downwards on the edge with the hands (fig. 3) to moisten the aluminum bottom of the appliance evenly with cotton wool dipped in alcohol for food use (such as vodka or rum) taking care not to pour it onto the central plastic area (fig. You should therefore perform this operation away from flames or hot stoves. This prevents the formation of ice between the bowl and aluminum bottom of the appliance, making it easier to extract the bowl when preparation is complete. 3) Place the ingredients required by the recipe in the bowl (note: some ingredients may need to be mixed thoroughly before being placed in the bowl) and fit the lid by turning counterclockwise. Make sure there are no obstacles preventing air from circulating freely through the grilles at the sides. 5) Once you have added all the ingredients to the bowl, turn the appliance on by placing the selector in the position. Gelato should take 30-40 minutes to reach the desired consistency and should be checked periodically throughout preparation to ensure the gelato does not get too hard and freeze the paddle rotation mechanism. 6) Ingredients such as pieces of chocolate, raisins, and nuts should be added separately at the end of the freezing cycle about 5 minutes before gelato is ready. Important: never use the appliance without the bowl. [. . . ] Residents: Please contact our toll free hotline at 800-322-3848 or log onto our website at www. For all accessories, spare parts or replacement parts, please contact our parts division at 1-800865-6330. Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our website at www. The above warranty is in lieu of all other express warranties and representations. [. . . ]