User manual DELONGHI H 191016

[. . . ] If heater has leaked any oil, discontinue using the heater and contact the service center as indicated in this instructions leaflet. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. [. . . ] However, if you have to use an extension cord, the cord shall be No. 1 4 AWG minimum size and rated not less than 1875 watts, and has to be used only for supplying power to this heater. Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that receptacles also deteriorate due to aging and continuous use: check periodically if signs overheating or deformations are evidenced by the plug. Do not use the receptacle and CALL your electrician. Check that neither the appliance nor the power cable have been damaged in any way during transportation. Make sure that no pieces of polystyrene or other packaging material have been left between one element of the appliance and another. It may be necessary to pass over the appliance with a vacuum cleaner. When switching on the appliance for the first time, allow it to run at full power for about two hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is located is well ventilated during this operation. It is normal for the appliance to emit small cracking sounds when you turn it on for the first time. CAUTION: To prevent electric shock match wide blade of plug to wide slot, fully insert. IMPORTANT SAFEGUARDS SAVE THESE INSTRUCTIONS 2 GB 5-11-2003 9:00 Pagina 3 HOW TO USE YOUR HEATER FITTING THE WHEELS Remove the feet and the wheels from the polystyrene packing. Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. - Fit the wheels to the spindles on the feet and push firmly until they click into position. Pull each wheel to check that it is correctly inserted. - The feet with the casters must be fitted with two arc-shaped brackets only between the 1st and 2nd element (see fig. 1 to 4 inclusive) fig. 1 fig. 2 fig. 3 fig. 4 BE CAREFUL Operate the heater in upright position only (wheels on the bottom, controls on the top). Any other position could create hazard situation! ON/OFF Switches Pilot lights 850 750 WATTS WATTS BOTH 1600 WATTS WATTS ECONOMIZER For more economical use, the Min. Watt switches may be used individually, after unit has reached the operating temperature. With pilot lights ON, the heater is ON! 3 GB 5-11-2003 9:00 Pagina 4 1. LOCATION Place heater on floor beneath coldest window in the room or any desired location. Your heater will minimize the effect of cold drafts. The heater must not be located immediately below a socket-outlet. [. . . ] Wipe radiator with a soft damp cloth, do not use detergents and abrasives. Should the radiator not be in use over a certain length of time, wind the cable round the holder and store it in a dry place (see fig. This appliance has been built to give many years of trouble free service. In case of malfunction or doubt, do not try to repair the heater by yourself: it may results in fire hazard or electric shock. [. . . ]