User manual DELONGHI HCS 2032

[. . . ] · Do not obstruct the hot air outlet grilles or the air intake grille at the top or the bottom of the appliance. · If the power cable is damaged, it must be replaced by the manufacturer or an authorised service centre in order to eliminate all risk. · Do not use this appliance in rooms measuring less than 4m2. You should avoid positioning it in currents of air which could disturb operation of the heater. [. . . ] The correct fuse cover is identified by colour and a replacement may be obtained from your De'Longhi Authorised Repairer (see guarantee leaflet). · If a non-rewireable plug is cut off it must be destroyed immediately. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. · This appliance complies with European Economic Community Directive 89/336/EEC. 4 Electric Convector Heater HCS 1. Electrical connections - Before plugging into the mains, make sure the voltage of your mains supply corresponds to the value Volt indicated on the appliance and that the socket and power line are appropriate for the load required. - THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC AND ON ELECTROMAGNETIC COMPATIBILITY. Attaching the feet To fit the feet, proceed as follows: insert the foot into the guide on the side and push as far as it will go until the two teeth hook in place (fig. Wall mounting IMPORTANT: before drilling the wall, make sure the area is free of electrical wires or pipes. To fix your convector heater to the wall, use the brackets "E" and "F" provided and appropriate screws and wall plugs (provided). Proceed as follows: · Fix the brackets "E", making sure the distances are as shown in fig. · Hang the heater on the two brackets fixed to the wall. Insert the two brackets "F" in the back of the convector base as shown in fig. Mark the bracket fixing points on the wall. · Remove the heater, drill the wall and insert the wall plugs. · Fix the heater again, inserting the brackets "F" into the base of the heater and fixing them to the holes in the wall using the screws. The appliance must not be positioned directly underneath a fixed power point. Position the appliance in such a way that the plug is easily accessible even after installation. Operation and use Turning on Plug into the mains, turn the thermostat dial (B) to maximum and turn the appliance on by means of the power selector (A) as described below. · Turn the selector (A) to the Min position to select minimum power (the Min power light comes on). · Turn the selector (A) to the Med position to select medium power (the Med power light comes on). · Turn the selector (A) to the Max position to select maximum power (the Max power light comes on). [. . . ] · Set the periods of time during which you want the appliance to operate by pushing the teeth outwards. Each tooth corresponds to a period of 15 min. At the end of this procedure, sectors corresponding to the operating periods can be seen. · In this way, the appliance will function automatically each day at the times set. (Important: the appliance must always be plugged into the socket) · To modify programming, return the teeth to the initial position and set the new operating periods. [. . . ]