User manual DELONGHI HHP 1500W

[. . . ] During this time ensure that the room is well ventilated. - the use of an extension lead is not recommended, however if it is necessary then follow carefully the extension lead's instructions, and most importantly ensure that the extension lead is correctly rated in accordance with the appliance being used and NEVER overloaded. - As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children. - Position the appliance so that the plug and the outlet can be easily reached even after installation. [. . . ] We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN ANDYELLOW EARTH BLUE NEUTRAL BROWN LIVE Green and Yellow to Earth 13 amp Fuse Brown to Live Blue to Neutral Cord Clamp As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the 4 HHP terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses which are asta approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. 2. General instructions Carefully remove the heater from the packaging. Check that neither the heater nor the power cable has been damaged during transport. Do not operate the heater if damaged. Your heater is suitable for either freestanding or wall mounting usage. Do not assemble the feet if wall mounting. Electrical connection - Before plugging the appliance into the mains, check that your supply voltage is the same as that shown on the rating plate of the appliance and that the electric installation is suitable to the power shown on the rating plate. - If using more than one appliance at a time, it is important to ensure that the power supply is adequate to cope with the power requirements. - This appliance complies with EEC Directive 89/336 relating to electromagnetic compatibility. Free standing operation To fit the feet to the appliance, proceed as follows: Unscrew the screws from the feet, then fix the foot with the relevant screws, as shown in the description of the appliance. HHP 5 5. [. . . ] Remove the appliance, drill the lower holes and insert the wall plugs. Now, you can hang the heater to the support and fix the lower part of the appliance with the 2 remaining screws (see figure1). - Turn the thermostat dial in a clockwise direction until it reaches the 6 setting. - Turn the function dial to setting 1 (the pilot light will come on). [. . . ]