User manual DELONGHI HMH 443/3 T

[. . . ] - It is important to ensure that the socket is adequately earthed. - This appliance complies with EEC directive 89/336 regarding electromagnetic compatibility. Installation (If required) Models with a motorised base can be wall-mounted, using 3 screws and 3 wall plugs. To wall-mount, proceed as follows: Drill holes in the wall, as shown in Fig. 1, paying particular attention to the minimum distances indicated. [. . . ] Each "tooth" represents 15 minutes. Using your thumbnail push the teeth to the outer rim of the timer to indicate when you require the heater to be off. - Ensure the heater is on at the mains and set to the heat setting (using the function selector) and temperature level on the thermostat as desired. - The heater will now function automatically everyday, switching on and off according to your selection (IMPORTANT ­ the heater must always be plugged in and a heat setting selected). - If you wish to operate the heater without using the timer simply push all the teeth into the centre (as when the heater was first supplied). Models with a motorised oscillating base Some models feature a motorised oscillating base to distribute the airflow over a larger area. To turn the oscillation on press the footswitch at the front of the heater. To stop the heater in a particular position, simply press the footswitch again. The heater can also be tilted manually on its base to vary the airflow up and down. Please note: This heater is fitted with a tip over switch, which turns the heater off should it be accidentally knocked over. To restart the heater, simply place it upright again. HMH 4 Cleaning and maintenance The heater should not require any maintenance. However before attempting to clean the heater, unplug from the mains and wait for it to cool (this should take around 5 minutes). It is sufficient to remove external dust with a soft, dry cloth. If necessary, remove concentrated areas of dirt with a vacuum cleaner. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Only use the heater in an upright position. - The heater must be positioned at least 50cm from walls, curtains, furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. - Do not use this appliance in rooms which have a floor area smaller than 4m2 as this may lead to overheating. [. . . ] WARNING:Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ]