User manual DELONGHI HMH 550 R

[. . . ] If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] 4) to the desired comfort temperature, from * (5°C) and max (35°C). If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heating the room until it reaches the selected temperature. The unit will automatically mantain the temperature at a constant level, by cycling between "max", "med" and "min", as it approaches the selected comfort temperature. If the room temperature exceeds the selected temperature level, the appliance will turn itself off. Selected power Power used MAX MAX MAX MED MAX MIN MAX OFF The appliance will turn on automatically again when the room temperature falls below the selected temperature level. If a power level below "P max" has been selected using the "ON/OFF" button, the appliance will modulate between the selected level and the lower power levels. ANTIFREEZE FUNCTION Press the "ON/OFF" button to select the "P max" power level. Set the thermostat dial to the " " position (Fig. When set in this way, the appliance will turn on automatically only if the room temperature falls below 5°C, to prevent it from freezing at minimum energy consumption. This function is not guaranteed in the event of black outs, even if lasting just a few seconds. * MODELS WITH ROTATING BODY This appliance is fitted with a motorized base and a rotating body. To distribute the air flow over a larger area, push the foot switch (Fig. When activated, the appliance will oscillate from right to left over an angle. To stop the appliance in the desired position, simply push the foot switch again (a beep will confirm the selection) 5 01_HMH 550R_GB. qxd 6-08-2003 14:01 Pagina 6 Fig. 5 MODELS WITH REMOTE CONTROL Some models are equipped with a remote control to provide ease of operation. The appliance can be completely controlled with the remote control. Two AAA 1, 5V batteries are required (not included): · remove the cover located on the back side of the remote control; · insert the two AAA 1, 5V batteries positioning them correctly (see the instructions in the batteries compartment); · replace the cover. REMOTE CONTROL OPERATION - When you press the "ON power selection" push button, the appliace operates at the maximum power. Each further pression of the "power selection" push button, the power will change from MAX to MED/MIN/MAX. - If you desire to operate with the fan only, press the "Fan Only" pushbutton. - Only when a function is selected it is possible to activate the rotation of the appliance, by pushing the "ON/OFF oscillating base" push button. - The "Off" push button switches off the appliance. [. . . ] - If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. - Do not use the appliance in rooms less than 4 m2 in area. - The appliance must be installed so as the buttons and other controls are out of the reach of person in the bathtub or shower. The appliance is fitted with a tilt-switch which turns the appliance off if it should fall over. [. . . ]