User manual DELONGHI HR 720

[. . . ] We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. Important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: Warning - this appliance must be earthed As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. [. . . ] Only 13amp replacement fuses which are asta approved to B. ASSEMBLING THE FEET To fit the feet to the appliance, proceed as follows: Insert the foot ensuring that the bigger hole A on the foot coincides with the screw mounted on the base of the convector (see figure 1); then screw in the remaining three screws (see figure 2) which are supplied. Note: the convector must be used only with the feet correctly fitted!ELECTRICAL CONNECTION - Before inserting the plug into an electrical outlet, check carefully to be certain that the voltage in your home's electrical system matches the voltage (V) indicated on the appliance and that the socket and mains feed are sufficient to power the appliance. OPERATION AND USE TURNING ON Plug the appliance into the mains socket and turn the thermostat knob to maximum. ADJUSTING THE THERMOSTAT When the room has reached the desired temperature, turn the thermostat knob slowly in an counterclockwise direction until you hear a click and the appliance turns off (indicator light off). The thermostat will now keep the temperature in the room constant, turning the heater on and off as appropriate. MAINTENANCE Always unplug from the mains socket and allow to cool down before cleaning the appliance. This electric heating convector does not require any special maintenance. All you have to do is dust it off with a soft, dry cloth ­ but do so only when the appliance is cool. never use abrasive powders or solvents. WARNINGS ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. ⷠDo not use the appliance to dry laundry. ⷠDo not make use of this heating convector in the immediate proximity of bathtubs, showers, washbasins, pools, etc. [. . . ] A safety device intervenes and turns off the appliance in the event of overheating or because the appliance is positioned in a strong draught of air. To reactivate it, remove the plug from the electrical outlet, allow the appliance to cool, remove the cause of the overheating/draught and then reconnect the appliance to the mains and turn it back on. The use of extension leads is not recommended as they could overheat while the appliance is in use. [. . . ]