User manual DELONGHI HS 20-2

[. . . ] Assembling the feet Fit the feet to the appliance as follows: - Insert the anchor pins into the slots and turn the foot until it clicks into position (fig. 1) - Fasten the feet in position using the screw (fig. 2) Wall mounting Before drilling into any wall ensure no electrical cables are present in the area. In order to wall mount your convector please proceed as follows: 1. [. . . ] To turn the appliance off, rotate the thermostat dial fully anticlockwise and remove the plug from the socket. Models with two switches and thermostat Turn the thermostat dial clockwise until it can be turned no further, then press the bottom of the left switch (minimum power) or both switches (maximum power) so the red area at the top of the switch(es) is showing. We suggest that on days when temperatures are not particularly cold, select minimum output to optimise savings on energy consumption. Adjusting the thermostat (where applicable) When the room has reached the desired temperature, turn the thermostat dial slowly in an anti-clockwise direction until you hear a click and the appliance turns off. The thermostat will now keep the temperature in the room constant, turning the heater on and off as appropriate. Frost protection function (only on models with a thermostat) Turn the thermostat dial fully anti-clockwise to the position. If your convector has one switch, press this on. If your convector has two switches press one or both switches on. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent freezing at minimum energy consumption. Cleaning and maintenance The convector should not require any maintenance. However before carrying out any cleaning or maintenance, unplug the heater from the mains and wait for it to cool (this should take around 5 minutes. It is sufficient to remove external dust with a soft, dry cloth. If necessary, remove concentrated areas of dirt with a vacuum cleaner. Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. - Never place the power cable on top of the heater while it is hot. - Only use the heater in an upright position. HS 4 - Do not block the outlet grilles at the top of the heater or the intake grille at the bottom of the heater. - The heater must be positioned at least 50cm from furniture or other objects. - If the power cable is damaged, it must be replaced by the manufacturer or an authorised technical service centre. - Do not use this appliance in rooms which have a floor area smaller than 4m2. - We recommend that you do not place the heater in a draught as this may adversely affect the appliance's operational efficiency. - The heater must never be placed immediately under a fixed mains socket. - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. - A safety device intervenes and turns the appliance off in the event of overheating or because the appliance is positioned in a strong draught of air. [. . . ] If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below. IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The blue wire must be connected to the terminal marked with the letter N or coloured black. [. . . ]