User manual DELONGHI HVF 3533 B

[. . . ] · If the power cable is damaged, it must be replaced by the manufacturer or an authorised service centre in order to eliminate all risk. · The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. · Do not use this appliance in rooms measuring less than 4m2. [. . . ] In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below. IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red. If you have a 3-pins plug, do not connect any wire to the "earth" terminal. Fan Heater HVF3533 4 Dear Customer ­ The plug on this appliance will get `warm' during use, this is perfectly normal. This product is A HIGH POWER HEATING APPLIANCE designed to our usual high standards but please make sure your wall sockets are in good condition and the plug is inserted correctly to avoid any accidental overheating. We suggest that you check the plug AND THE SOCKET regularly if the heater is in prolonged use, if you are in any doubt please consult an electrician. WALL MOUNTING INSTALLATION The appliance may be either portable or wall-mounted (if supplied with a bracket). Models with motorised base cannot be wall mounted. To mount on the wall, proceed as follows: - Fix the bracket to the wall respecting the minimum measurements indicated (fig. - Attach the appliance to the top hook of the bracket, then rotate gently until it hooks to the bottom tooth of the bracket (fig. - The appliance must not be placed immediately under a fixed power socket. Note: If you do not intend to wall mount the appliance, do not attach the bracket to the unit. FUNCTIONING AND USE Models with function selector and thermostat. Make sure the appliance is off before plugging into the mains. If your appliance has a timer, see the section "Models with 24 hour timer". However, to operate the appliance without programming, move all the teeth of the timer to the outside. Summer mode (fan only): turn the function selector to the position. Low power operation: turn the function selector to position 1 (in models with two fan speeds, the fan operates at minimum). Medium power operation: turn the function selector to position 2 (in models with two fan speeds, the fan operates at maximum). High power operation: turn the function selector to position 3 (the fan operates at maximum). [. . . ] To distribute the air flow over a larger area, press the pedal. The appliance swings from right to left. To stop the appliance in the desired position, simply press the pedal again. Models with motorised base are fitted with a tip-over switch which turns the appliance off if it falls over. [. . . ]