User manual DELONGHI HVK 1020

[. . . ] GB Voltage Wattage See rating label ELECTRICAL CONNECTION Before plugging into the mains, make sure the voltage of your mains supply corresponds to the value in Volts indicated on the appliance. Make sure the mains socket is rated at 10/16 Amps. THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC AND D. M. [. . . ] FROST PREVENTION CYCLE Turn the left-hand knob to position 2, then turn the right-hand thermostat knob to the position. The appliance is set to maintain a temperature of about 5°C in the room with minimum energy consumption. Models with switch Heating at low power: press the "-" switch (the red zone is visible on the switch). Heating at high power: press both switches (the red zone is visible on the switches). Turning the appliance off: turn off both switches. You should always unplug the appliance from the mains when not in use. Models with thermostat only To turn the appliance on, turn the knob clockwise as far as it will go to maximum position. To turn the appliance off completely, turn the knob to the minimum position, then unplug from the mains. CLEANING AND MAINTENANCE Always unplug the heater from the mains socket before cleaning. Clean the air intake and outlet grilles frequently Do not use abrasive cleaning products or solvents. IMPORTANT Do not use this heater near showers, bathtubs, sinks, swimming pools, etc. Always use the heater in an upright position. Never obstruct the intake and outlet grilles (danger of overheating). The heater must be positioned at least 50 cm from furniture or other objects. [. . . ] obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again. Important: Never under any circumstances cover the appliance during operation as this would lead to dangerous overheating of the appliance itself. 4 [. . . ]