User manual DELONGHI HVY 1020

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red. [. . . ] The thermostat will then keep room temperature at the selected level automatically. 2 1 Frost prevention mode With the function selector 2 in position 3 (position 2 for models with two power levels only) and the thermostat dial 1 in position , the appliance maintains room temperature at about 5°C, preventing freezing with minimal energy consumption. 2 MODELS WITH THERMOSTAT ONLY To switch the appliance on, turn the thermostat dial 1 clockwise to maximum (the light comes on). 2 To switch the appliance off completely, turn the knob to the position, then unplug from the mains. For the frost prevention function, turn the thermostat dial 1 to the position and leave the appliance plugged into the mains. 2 MAINTENANCE - Always unplug from the mains socket before cleaning. - Clean the air intake and outlet grilles regularly. - Do not use abrasive products or solvents to clean the appliance. 6 2 IMPORTANT - Do not use this appliance near showers, baths, swimming pools, etc. - Always use the heater in an upright position. - Do not cover the appliance when in operation to avoid the risk of fire. Never obstruct the intake and outlet grilles (danger of overheating). - The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children must be supervised to ensure they do not play with the appliance. - The heater must be positioned at least 50 cm from furniture, walls, curtains, or other objects. - The appliance must not be positioned near walls, furniture, curtains etc. - The use of extension leads is not recommended. However if they cannot be avoided, follow the instructions accompanying the extension lead and never exceed the power limit marked on the extension. - If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. - Do not use the appliance in rooms measuring less than 4 m². [. . . ] För att återställa funktionen måste du dra ut stickproppen och vänta i några minuter, åtgärda orsakerna till överhettningen och sedan sätta i stickproppen igen OBS: För att undvika risker till följd av att överhettningsskyddet återställs av misstag får det inte finnas några externa omkopplare (t. Den kan överlämnas till lokala myndigheters avfallssorteringscentraler eller till en återförsäljare som ger denna service. - Hvis el-ledningen er beskadiget, skal den udskiftes af fabrikanten eller af et af dennes tekniske servicecentre eller i alle tilfælde af en faguddannet person for at undgå enhver form for fare. For at tænde for apparatet igen, skal du tage stikket ud af stikkontakten og lade apparatet køle af i et par minutter, fjern årsagen til overophedningen, og sæt stikket i stikkontakten igen. [. . . ]