User manual DELONGHI IH 2

[. . . ] GB 1-03-2002 14:28 Pagina 3 RADIANT HEATER Technical Data Type Category Maximum Input KW 4. 20 g/h 305 KW 1. 50 Low Input g/h 109 28÷30 mbar Gas pressure see rating label This appliance is designed to operate with Butane, propane or mix LPG at nominal pressure: 28 ÷ 30 mbar. For a correct gas combustion the required air quantity is 8, 4 m3/h. WARNINGS ALWAYS use heater in accordance with instructions. Read the instructions book carefully and keep it in a safe place. [. . . ] Special care should be taken if the heater is on a surface where it can move or twist on its wheels or castors if knocked by a child or dog, etc. - Minimum Clearance : 200 mm from sides, 1500 mm from front. - Before using for the first time, turn on the appliance and leave to heat for at least 15 minutes with the thermostat on maximum to eliminate the smell of `newness" and any fumes from the protective substances applied to the elements before transport. Safety devices The heater you have purchased is fitted with safety devices which come on in the event of malfunctioning while the appliance is in use. If the pilot light (placed opposite the burner) accidentally goes out, or if the room is not sufficiently ventilated, the safety device will block the gas flow, causing the heater to go off. Gas leakages If a leak is suspected, turn off gas at the gas bottle, open the window and air the room. DO NOT disconnect the pressure regulator. Slowly turn the gas on 3 GB 1-03-2002 14:28 Pagina 4 and brush the connections with soapy water or liquid detergent - a gas leak will form bubbles. If a leak is found, turn the gas off and inform your Dealer. DO NOT use the heater again until it has been inspected by your Dealer. NEVER USE MATCHES TO FIND LEAKS. GENERAL SAFETY INSTRUCTIONS Gas bottle Gas Bottle with 15 kg of maximum capacity can be installed. Changing of gas bottle must not be carried out in the presence of a naked flame. Use the gas bottle always in upright position. If a screw on regulator is used ensure that the regulator washer is present and in good condition -replace if in any doubt. To place the bottle in position, remove the rear panel which faces the inside during transport, by unfastening the screws; than put the bottle in position and replace the panel. [. . . ] This ensures removal of the products of combustion and allows the entry of replacement air. The following table shows the smallest size of room suitable for each heat setting and the dimensions of the aperture which must be provided equally divided between high and low level, according with the maximum, medium or minimum power. Room Size Room Aperture 42 m3 105 cm 2 Safety guard The guard is to prevent risk of fire and no part of it should be permanently removed. It does not give full protection for young children or the infirm. 4 [. . . ]