User manual DELONGHI IHF REG WHITE/WHITE

[. . . ] 4 - DO NOT position heater alongside a wall or near curtains or arm-chairs etc. ALWAYS face heater towards centre of room. Special care should be taken if the heater is on a surface where it can move or twist on its wheels or castors if knocked by a child or dog, etc. Minimum Clearance : 200 mm from sides, 1500 mm from front. [. . . ] Please read carefully and follow the instructions. Do not turn the bottle upside down to use completely its content. Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig. 5). Check the expiry date and state of the rubber tube regularly. If it is past its expiry date or has been damaged, replace it with one which complies with the current regulations. Avoid bending or constricting the rubber tube when the fig. 5 pressure regulator is connected to the gas cylinder. This heater must be used with an approved Low Pressure Regulator which complies with SAB S1237. The regulator is required to reduce the pressure of the gas in the cylinder from about 700 kPa to about 2, 8 kpa to operate the radiant - the heating panels. Ventilation USE ONLY IN A WELL VENTILATED ROOM Adequate ventilation must be provided in rooms in which the heater is used. This ensures removal of the products of combustion and allows the entry of replacement air. The following table shows the smallest size of room suitable for each heat setting and the dimensions of the aperture which must be provided equally divided between high and low level, according with the maximum, medium or minimum power. Control knob setting Position small flame (low rate) Position big flame (maximum rate) Position medium flame (medium rate) Room Size Room Aperture 15 m3 42 m3 105 cm 2 28. 5 m3 Safety guard The guard is to prevent risk of fire and no part of it should be permanently removed. It does not give full protection for young children or the infirm. 3 OPERATING INSTRUCTIONS Lighting the heater 1. FROM « l» POSITION, fully depress the control knob for 10 seconds and turn to (Small Flame) position. (If pilot flame does not ignite return to starting position and repeat). Continue to fully depress the knob for a further 20 seconds to allow the thermocouple probe to heat up, then turn the knob to select the desired setting as follows: (Small Flame) Low Input ((Big Flame) Maximum Input, (Medium Flame) Medium Input, In the event of "burn back" turn off and try again. Should it happen a second time return the until to the dealer. Auxiliary ignition Should piezoelectric starter fail to work, repeat operation on control knob and use a match to light pilot flame. Turning off the heater Turn off the gas bottle tap. The Heater will be totally "OFF" only if the tap at the gas bottle is turned off. Important When the operating knob is left at the end of the starting time (see rating plate), this must move up about 5 mm and return to his starting height. If this does not happen, shut the gas valve and contact your aftersales service centre. [. . . ] DIARISE: During March/April of each year check the "O" Ring Seal. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. MAINTENANCE Wipe your appliance with a soft damp cloth and only when it is switched off, cold and unplugged. Do not use solvents or abrasives detergents. [. . . ]