User manual DELONGHI KBB 2410

[. . . ] We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. IMPORTANT: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] Never use the kettle without it's lid. Position the kettle properly on the power base before switching on. Use the kettle only with the power base supplied (and vice versa). Do not operate this kettle if the mains lead or plug is damaged, if the kettle malfunctions, or has been damaged in any manner. It must be returned to a service agent for repair or replacement in order to avoid hazard. The power cable must not be replaced by the user, as this requires the use of special tools. If the power cable is damaged, contact an authorized Service Centre. If the kettle is overfilled, boiling water may overflow. 4 BEFORE USE Remove all packaging from the kettle and power base. Remove any labels from the outer stainless steel surfaces. Remove the filter by pushing as shown in fig. "Removing the scale filter" Fill the kettle and boil. The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. After the kettle has been rinsed out, re-fit the filter (fig. 3). 1 IN USE Power base with 360 access 2 3 With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. Do not leave loose cord hanging over the edge of work surfaces. Storage cable 4 Filling Remove the kettle from the base unit before filling. Open lid and fill kettle to desired level. Do not fill with less than 0, 25 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the life of the element. Do not fill with more than 1, 7 litres of water (up to the MAX indication located inside the kettle) (fig. If the kettle is overfilled, there is a risk that boiling water may be ejected causing burns. MAX 1, 7 litres MIN 0, 25 litres 5 5 Switching on Plug the power base into the mains socket. [. . . ] Disconnect the appliance from the mains electrical supply. Make sure that your hands are clean and free from soap, cream or anything which might taint the water. Empty the kettle and remove the filter by pushing as shown in fig. Rinse under a tap whilst brushing with a soft brush (fig. [. . . ]