User manual DELONGHI KBG 24

[. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. [. . . ] · Do not operate this kettle if the mains lead or plug is damaged, if the kettle malfunctions, or has been damaged in any manner. It must be returned to a service agent for repair or replacement in order to avoid hazard. · The power cable must not be replaced by the user, as this requires the use of special tools. If the power cable is damaged, contact an authorized Service Centre. · If the kettle is overfilled, boiling water may overflow. 4 BEFORE USE · Remove all packaging from the kettle and power base. · Remove any labels from the outer stainless steel surfaces. "Removing the scale filter" · Fill the kettle and boil. · The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. · After the kettle has been rinsed out, re-fit the filter (fig. 3). c a b 1 IN USE Power base with 360° access With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. · Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. · Do not leave loose cord hanging over the edge of work surfaces. 1 2 2 3 4 Filling · Remove the kettle from the base unit before filling. · Open lid and fill kettle to desired level. Do not fill with less than 0, 25 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the life of the element. Do not fill with more than 1, 7 litres of water (up to the MAX indication located inside the kettle) (fig. If the kettle is overfilled, there is a risk that boiling water may be ejected causing burns. MAX 1. 7 litres Lt Lt MIN 0. 25 litres 5 5 Switching on · · · · · Plug the power base into the mains socket. The kettle will automatically switch off once the water is boiled (the ON/OFF switch will click upwards and the lights will go out). · To turn the kettle off before the water boils, you may move the ON/OFF switch up to the OFF position, or simply lift the kettle from its base - it will switch off and the switch will return to the OFF position automatically. 0 I 6 Pouring · Remove the kettle from the power base and carefully pour out the water. Do not tilt kettle suddenly or pour out at too sharp an angle. · When you lift the kettle from the base, you may see moisture on the top surface of the base. This is condensation from the steam that causes the kettle to turn off automatically after boiling. [. . . ] · Rinse under a tap whilst brushing with a soft brush (fig. 3). To clean the scale filter It is vital to clean and descale regularly in order to maintain good working order · Use a proprietary descaling product e. g. We recommend using citric acid crystals as follows: · Pour into kettle about 50 gr. of citric acid cristal and then fill with water up to the max level indicated and then boil. [. . . ]