User manual DELONGHI KBO 2001 B

[. . . ] · The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. · Young children should be supervised to ensure that they do not play with the appliance. · Do not allow the mains lead to hang over the edge of the table or work surface, or anywhere it may be accidentally caught or tripped over. [. . . ] The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. IMPORTANT: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. Only 13amp replacement fuses which are ASTA approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. WARNING - THIS APPLIANCE MUST BE EARTHED Green and Yellow to Earth 13 amp Fuse Blue to Neutral Brown to Live Cord Clamp 5 BEFORE USE · Remove all packaging from the kettle and power base. · Remove any labels from the outer stainless steel surfaces. "Removing the scale filter" · Fill the kettle and boil. · The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. · After the kettle has been rinsed out, re-fit the filter (fig. 3). c a 1 1 2 2 3 b IN USE Power base with 360° access With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. · Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. · Do not leave loose cord hanging over the edge of work surfaces. Filling · Remove the kettle from the base unit before filling. 4 · Open lid and fill kettle to desired level. Do not fill with less than 0, 3 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the life of the element. [. . . ] · Rinse under a tap whilst brushing with a soft brush (fig. 3). To clean the scale filter It is vital to clean and descale regularly in order to maintain good working order · Use descaler for kettles. When limescale starts forming on the heating element, buy a suitable descaler and descale according to the instructions given on the descaler pack. After descaling, boil the kettle repeatedly with fresh water and rinse thoroughly to completely eliminate all residues of descaler which could damage the appliance. [. . . ]