User manual DELONGHI KBX 2016

[. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. [. . . ] · Use the kettle only with the power base supplied (and vice versa). · Do not operate this kettle if the mains lead or plug is damaged, if the kettle malfunctions, or has been damaged in any manner. It must be returned to a service agent for repair or replacement in order to avoid hazard. · The power cable must not be replaced by the user as this requires the use of special tools. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. · If the kettle is overfilled, boiling water may overflow. · Failure to observe these cautions may result in damage to the kettle. · Materials and accessories coming into contact with food conform to EC regulation 1935/2004. 4 BEFORE USE · Remove all packaging from the kettle and power base. · Remove any labels from the outer stainless steel surfaces. "Removing the scale filter" · Fill the kettle and boil. · The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. · After the kettle has been rinsed out, re-fit the filter (fig. 3). c a b 1 IN USE Power base with 360° access With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. · Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. · Do not leave loose cord hanging over the edge of work surfaces. 1 2 2 3 4 Filling · Remove the kettle from the base unit before filling. · Open lid and fill kettle to desired level. Do not fill with less than 0, 5 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the MAX 1. 7 li lt life of the element. MIN 0. 5 lt Do not fill with more than 1, 7 litres of water (up to the MAX indication located inside the kettle) (fig. If the kettle is 5 overfilled, there is a risk that boiling water may be ejected causing burns. A handy external water level indicator enables you to see the quantity of water in the kettle. 5 Switching on · · · · · Plug the power base into the mains socket. The kettle will automatically switch off once the water is boiled (the ON/OFF switch will click upwards and the lights will go out). [. . . ] of citric acid cristal and then fill with water up to the max level indicated and then boil. Allow the contents to cool, and then rinse thoroughly. · Do not use a more concentrated solution. If the filter requires descaling, remove the filter and place into the citric acid solution in the kettle. [. . . ]