User manual DELONGHI KH 590510M

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ] A) Models with single switch (1 power level): button in position «I» = Total power on (indicator light on); button in position «O» = (indicator light off) b) Models with double switch (3 power levels) button in position «l» = minimum power (indicator light on); button in position «ll» = intermediate power (indicator light on); both buttons in position «l» «ll» = maximum power (indicator lights on) To turn appliance off, switch off both switches or remove plug from wall socket. Adjusting the thermostat When the room has reached the required temperature, turn the thermostat slowly anticlockwise until the indicator light goes out (or until you hear a "click") and no further. The set temperature will then be regulated automatically and kept constant by the thermostat. Frost protection function With the thermostat in position and the switches pressed, the appliance maintains the room at a temperature of about 5°C, preventing freezing with minimum energy consumption. C) Models with a 24 hour time-clock (fig. 00, turn the numbered timer disk clockwise until the number 10 on the disk coincides with the pointer s on the timer. Set the periods of time when you want the appliance to work by pushing the teeth inwards. Each tooth corresponds to a period of 15 minutes. This will leave visible sectors which correspond to the periods of operation. When set, the radiator will operate automatically each day during the times programmed (important: the radiator must always be plugged into the socket). - To change the programming, move the teeth back into the initial position and set the new periods of functioning. If you want to make the appliance operate without programming, push all the teeth into the centre. In this case, to turn the appliance off completely, as well as turning the switches off, you must also unplug it from the mains to avoid continued operation of the timer. TURBO HEATING Some models are fitted with a heating fan which heats the room more quickly. To turn this function on, push the button into the position. Important: a safety device cuts in and switches off the appliance if it overheats due to an accumulation of dust on the air intake and output grills. To restart it, unplug from the mains and leave the appliance to cool down. Clean the air intake and output grills with a vacuum cleaner, then replug into the mains and turn on again. [. . . ] - When you start the radiator for the first time, leave it operating at maximum power for at least two hours. During this operation, ventilate the room well to eliminate the "new" smell emanating from the appliance. - It is normal for the appliance to emit a squeaking noise when turned on for the first time. - The appliance must never be placed immediately under a fixed mains socket. [. . . ]