User manual DELONGHI MG 15E

[. . . ] Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. Do not cover cord with throw rugs, runners, or the like. [. . . ] Fit the wheels to the spindles on the feet and push firmly until they click into position. Pull each wheel to check that it is correctly inserted. The feet with the casters must be fitted with two arc-shaped brackets only between the 1st and 2nd element (see fig. 2 Pilot lights 900 600 WATTS WATTS BOTH 1500 WATTS fig. LOCATION Place heater on floor beneath coldest window in the room or any desired location. Your heater will minimize the effect of cold drafts. The heater must not be located immediately below a socket-outlet. Do not use this radiator in rooms having a surface area less than 4 m (43 sq. CONNECTION 2 The radiator must be connected to a properly polarized A/C 110/120 V household outlet in perfect working conditions. Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater plug is fitted in. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 3 GB 31-01-2002 14:40 Pagina 4 OPERATION AND USE 1) SETTING THE CLOCK For the first time, set the clock to the correct time, proceeding as follows: · Press the button "hour" until the display shows the hours for the correct time, then release the button. · Press the button "min" until the display shows the minutes for the correct time, then release the button. When setting the correct time, the numbers will flash on the display. The flashing of the numbers will continue for a few seconds after the adjustment has finished then stop on the correct time and the clock start working. To change the time, press pushbuttons "hour" or "min" for at least 5 seconds, then proceed as above to modify both hours and minutes. AM MAN correct time 0 : Set temperature °F 2) MANUAL FUNCTIONING To operate the appliance in "manual" mode, press the "ON MODE" button. To set the required power level, proceed as follows: press the "ON MODE" button, and then press again one or more times within 5 seconds to select the power level, as per the following sequence: AM MAN Maximum power : AM MAN °F Medium power : AM °F MAN Minimum power : AM °F MAN Off 0 : °F At any time during "Manual" operation, pressing the "ON MODE" button once will display the previously set power level for 5 seconds; after this 5 second period, the display will return to show the current operating power. If Maximum power has been selected, adjust the "+" or "-" button to the desired comfort temperature, from 42 to 95°F (5 to 35°C). By pushing once the "+" or "-" button the desired temperature (shown on the right side of the display) will increase or decrease of 1°F. Keep pushbutton pressed to move through the temperature in fast mode. AM MAN correct time : set temperature °F 4 GB 31-01-2002 14:40 Pagina 5 This heater has Electronic Climate Control which automatically monitors and selects the ideal power setting to maintain your chosen temperature. If the selected temperature is higher than the actual room temperature, the appliance will start automatically and rapidly heat the room until it reaches the selected temperature. [. . . ] Wipe radiator with a soft damp cloth, do not use detergents and abrasives. Should the radiator not be in use over a certain length of time, wind the cable round the holder and store it in a dry place (see fig. This appliance has been built to give many years of trouble free service. In case of malfunction or doubt, do not try to repair the heater by yourself: it may result in fire hazard or electric shock. [. . . ]