User manual DELONGHI PAC 1000

[. . . ] - The Pinguino should not be installed where the atmosphere could contain combustible gases. - Avoid using Pinguino in oily or sulphurous atmospheres or near sources of heat. - Before moving the air-conditioner, empty water from collection tray (see instructions for drainage at page 7). [. . . ] This will increase the efficiency and economy of the air-conditioner. · Do not place objects of any kind on the airconditioner. Close the door Lower the blinds Close the windows Do not cover Draw the curtains 8 YOUR AIR-CONDITIONER IS NOW READY FOR USE GB 14-05-2001 8:18 Pagina 9 CONTROL PANEL ON/OFF signal lamp TIMER ON signal lamp "Alarm" warning light "Ventilation" signal lamp "Air-conditioning" signal lamp Dehumidifier pilot lamp Min. speed signal lamp Water trap full pilot lamp Max. speed signal lamp Dehumidifier ON/OFF button 1 2 O I OFF 4 5 6 7 8 9 3 ON A B C D E Timer notches Thermostat knob ON/OFF main switch key Timer key Fan speed selection key Ventilation selection key Air-conditioning SETTING THE TIMER The programmer/timer, like all clocks, must be set to the exact time. If for example it is 4:00 p. m. , turn the dial in a clockwise direction (following the direction of the arrow) until the number 4 (4 p. m. ) is lined up with the arrow pointer (the arrows indicates 4:00 p. m. approximately). PROGRAMMED MODE 1) Release timer button B . 2) Set the operating times by pushing out the notches on the dial corresponding to the period required (each notch represents 15 mins. ). 3) Check that the timer indicates the correct time (see instructions on setting). Funzionamento Operating time 11 10 9 eg. from 9 to 11 a. m. 4 11 10 9 4 arrow pointer N. B. : Never turn the dial in a counter-clockwise direction!The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the programmer stops (the clock is then "slow") and must be re-set. The unit can be used in either programmed or non-programmed mode. 4) Select the desired function as shown in the chart overleaf. The unit will now switch on and off each day at the selected times. N. B: To override the programmed operating times, simply press the ON/OFF timer key. NON-PROGRAMMED MODE 1) B TIMER button must be pressed 2) Select the desired function as shown in the chart on the following page. 9 GB 14-05-2001 8:18 Pagina 10 HOW TO START UP THE AIR CONDITIONER Plug the appliance into the wall socket. The ON/OFF signal lamp (2) comes on and stays on for as long as the appliance is connected to the socket. Select either Programmed or Non-programmed mode (see previous page). Select the fan speed required pressing "Fan speed" key D. AIR-CONDITIONING VENTILATION DEHUMIDIFICATION Key C (VentilationConditioning) must be released Turn the thermostat to Max. Press key A (ON/OFF) Signal Lamp 5 (Conditioning) and either 6 or 7 (Min. [. . . ] Notre obligation sous cette garantie est limitée au replacement ou à la réparation, gratuit en notre usine, de toutes les pièces défectueuses autres que les pièces endommagées durant le transport, qui nous seront retournées transport payé d'avance - endèans un an après la livraison à l'acheteur-utilisateur. Cette garantie ne sera applicable que si l'appareil a été utilisé selon les instructions du fabriquant qui accompagnament l'appareil, et sur courant alternatif (AC). Cette garantie remplace toutes autres garanties et représentations, exprimées ou impliquées, et toutes autres obligations ou responsabilités de notre part. [. . . ]