User manual DELONGHI PAC 180

[. . . ] PAC180 GB 16-05-2003 11:56 Pagina 17 Air-conditioner PAC 180 Instructions for use PAC180 GB 16-05-2003 11:56 Pagina 18 Carefully read this instructions booklet before installing or using this appliance. Only by doing so will you have the best results and enjoy the greatest safety when using the appliance. Please pay particular attention to the warnings on page 30. INTRODUCTION This is a conditioner of the air-to-air type composed of two units: one internal (which operates inside the room) and the other external (to be installed outside). These two units are joined together by a sheathing (of about 3 m. ) containing the refrigerant pipes, electrical power cables and condensation-discharge tube. TECHNICAL FEATURES Power supply voltage Cooling capacity* Number of fan speeds Max. [. . . ] Room temperature display Gives you the current room temperature. After about four (4) seconds, the display will show the temperature set previously. Sleep This button controls the night-time operations. CANCEL: Timer Cancels the setting on the ON/OFF timer. ON / OFF: Timer programming These buttons program the turning on and off of the air-conditioner. SET: Clock and timer verification Confirms the setting of the clock and the ON/OFF timer. Room thermostat These two buttons select the desired room temperature: button 11 lowers the temperature, button 11 increases it. Clock and timer programming These buttons set the hour and minutes for both the clock and timer. Reset I 1 A B C D E F G H 9 78 6 5 4 3 2 26 PAC180 GB 16-05-2003 11:56 Pagina 27 AIR-CONDITIONING FUNCTION This operation is ideal on especially hot days. First press the button to turn the appliance on. A beep will indicate that the air-conditioner has turned on, and the symbol will begin to blink. Now press the MODE button until the air-conditioning symbol appears on the display. At this point, set the temperature: to lower it, press the button. To select the fan speed, simply press the button repeatedly until you obtain the speed desired (minimum, medium, maximum and automatic). DEHUMIDIFYING FUNCTION It is a good idea to activate this operation when there is high humidity. First press the button to turn the appliance on. A beep will indicate that the air-conditioner has turned on and the symbol will begin to blink. Now press the MODE button until the dehumidifying symbol appears on the display. We should emphasise the importance setting the temperature so that it is lower than the room temperature: use the button until you get a temperature 4° C. When that takes place, the air-conditioning function will switch on. If the temperature difference between the room and that set up is already 4° C. or less, the dehumidifying operation alone will immediately switch on. (For further explanation, see the table. ) To select the fan speed, simply press the button until you get the desired speed. [. . . ] Have your electrical system checked out by a qualified electrician. Avoid using extension cords for the electric feed cable. Before any cleaning or maintenance, always pull the plug from its electric outlet. Never pull on the feed cable to move this equipment. [. . . ]