User manual DELONGHI PAC 47RHWHITE

[. . . ] If you have any doubts check with a qualified electrician. · Avoid using extension leads with the unit. · Before cleaning or maintenance operations, always unplug the unit from the socket. · Do not pull on or place strain on the power cable when moving the appliance. [. . . ] Carefully hold the panel in the centre and lower to its closed position. During the "water functioning" operation and in particularly silent locations (eg the bedroom) a slight gurgling sound may be heard. IN HIGH HUMIDITY CONDITIONS Water is extracted from the air in the room, this water is also used to cool the condenser. When the humidity is particulary high an excess of water may buid up in the internal tank. This can be drained by removing the bung from the drain hose 10 and draining into a suitable receptacle. IMPORTANT: if the room temperature is 32°C or over the airconditioner must be operated with with water in the tank. 19 ENGLISH These air conditioners can use both air and water to cool the condenser (the hot part) of the air conditioner. Turning on and Selecting functions ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the power supply shown on the rating plate; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug, otherwise have the socket replaced; · the socket is properly grounded. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. Delay on Start Up 1. A special safety device will delay the start of air conditionig by approximately 3 to 5 minutes when switching between functions or on initial start up. You may also experience a slight delay between changing from one function to another. VENTILATION/FILTRATION Rotate the function selector 13 clockwise. · Press the button 12 (the signal light "I" 11 will come on). · Place the large symbol in line with the reference mark to operate the unit at maximum fan speed. · Place the small symbol in line with the reference mark to operate the unit at minimum fan speed. AIR CONDITIONING FUNCTIONS To turn the unit on in air conditioning mode, proceed as follows: 1. Press the button 12 (the signal light "I" 11 will come on). HEATING Rotate the function selector knob 13 counter clockwise to the symbol: 2. Rotate the function selector 13 dial anticlockwise: · Place the large star symbol in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed. · Place the small star symbol in line with the reference mark to operate the unit in air conditioning mode at minimum fan speed. Now set the required temperature by rotating the room thermostat dial 14 . Note The temperature is not expressed in degrees. We therefore recommend rotating the room thermostat knob 14 to the maximum heat position. When the temperature in the room reaches the comfort level desired, the thermostat knob may be turned SLOWLY in a counter clockwise direction until the thermostat intervenes, turning off the operation. This programs the unit to the precise level of comfort required which will then be automatically maintained by the thermostat with considerable energy savings. When heating the signal light 15 is off. Note The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. When the desired room temperature has been reached, slowly turn the thermostat 14 in a clockwise direction until it arrives at the position where a click can be heard. The temperature selected in this way will automatically be regulated and maintained, and save energy. [. . . ] If it does not fit your socket, the plug should be cut off from the mains lead, and on appropriate plug fitted, as below. warning: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a mouldedon type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. [. . . ]