User manual DELONGHI PACA 1/94

[. . . ] · It is dangerous to alter or modify the unit's characteristics in any way. · The appliance must be installed in line with the relevant national legislation. · Should repairs be necessary, contact the nearest authorized Repair Service Center. Unauthorized servicing can be dangerous. [. . . ] You are recommended, however, not to set a temperature much below the outdoor temperature. DEHUMIDIFYING MODE Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). In dehumidifying mode, the appliance should be prepared in the same way as for air conditioning, with the air exhaust hose attached to enable the moisture to be discharged outside. To set this mode correctly: · Press the MODE button a number of times until the dehumidifying symbol appears. In this mode, fan speed is selected automatically by the appliance and cannot be set manually. 8 Operation FAN MODE When using the appliance in this mode, the air hose does not need to be attached. To set this mode correctly: · Press the MODE button a number of times until the fan symbol appears. · Select the required fan speed by pressing the FAN button. Three speeds are available: Maximum speed: for maximum fan power Medium speed: reduces noise levels but still maintains a good level of comfort Low speed: for silent operation In this mode, AUTO speed cannot be selected. SMART MODE The appliance chooses automatically whether to operate in air conditioning or fan. Fan speed is also set automatically according to the conditions. To set this mode: · Press the MODE button a number of times until the SMART symbol appears. BOOST FUNCTION Ideal for the summer to cool rooms rapidly. To set this mode: · Press the button. The appliance operates in air conditioning mode at maximum fan speed. During air conditioning, the temperature increases by 2°F (1°C) after 60 minutes and 4°F (2°C) after 2 hours. SELECTING THE TEMPERATURE SCALE Press the button to switch the temperature scale from Centigrade to Fahrenheit and vice-versa. PROGRAMMING THE TIMER The appliance can be programmed to start up and shut down when required. Programming start up · Press the button. The start-up time and message ( ) flashes on the remote control display. · Press the or buttons to set the time you want the appliance to start up. · When that time is reached, press the OK button to confirm. The message ( ) appears on the remote control display and the symbol is displayed on the appliance to indicate that the timer is active. 12 Self-diagnosis Programming shutdown · Press the button. The shutdown time and message ( ) flash on the remote control display. · Press the or buttons to set the time you want the appliance to shut down. · When that time is reached, press the OK button to confirm. The message ( ) appears on the remote control display and the symbol is displayed on the appliance to indicate that the timer is active. SELF-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display. IF. . . IS DISPLAYED, WHAT SHOULD I DO? The appliance is fitted with a frost protection device to avoid excessive formation of ice. [. . . ] This delay is part of normal operation. · · See the self-diagnosis chapter. 16 Technical specification TECHNICAL SPECIFICATION Power supply voltage Max. absorbed power during air conditioning Refrigerant Cooling capacity see rating plate " " " LIMIT CONDITIONS Room temperature for air conditioning 64 ÷ 95°F (18° ÷ 35°C) Dimensions of appliance: · width · height · depth · weight 18 in - 463 mm 30 in - 775 mm 15 in - 382 mm 70 lb - 32 kg Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a technical service centre appointed by the manufacturer only. The appliance should be disposed of by a specialist centre appointed by the manufacturer only. NEVER TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS, WAIT AT LEAST 4 HOURS BEFORE TURNING THE APPLIANCE ON This appliance is equipped with a 3 prong grounding plug. [. . . ]