User manual DELONGHI PACC 100

[. . . ] IMPORTANT SAFEGUARDS · Use this appliance only as described in this instruction manual. As with any electrical appliance, the instructions aim to cover as many eventualities as possible. Caution and common sense should be used when operating and installing this air conditioner. · This appliance has been manufactured to cool and dehumidify domestic environments and should not be used for other purposes. [. . . ] If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. If the setting is not confirmed within a few seconds, the display resets to stand-by. With the timer activated, the countdown before the programmed start up time is displayed and the timer in operation light (H) flashes. To cancel the timer program, press the timer button (D) again. How to program delayed shutdown · Delayed shutdown can be programmed in any operating mode (air conditioning/dehumidifying/fan). The last timer setting or the preset value 6. 0 flashes on the display. · Use the + (E) or - (F) button to set the number of hours delay before the appliance stops. During the first ten hours, you can select half hour intervals. For times greater than ten hours, one hour intervals can be selected. If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. When the timer is set, the timer in operation light (H) flashes. At the set time, the air conditioner shuts down and remains in stand-by. To cancel the timer program, press the timer button (D) again. 9 Using the remote control unit MODELS WITH REMOTE CONTROL · Point the remote control at the receiver (R) on the air-conditioner. · The remote control should be handled with extreme care. Do not drop it, expose it to direct sunlight, or leave it near sources of heat. DESCRIPTION OF THE REMOTE CONTROL 17) 18) 19) 20) 21) FAN button ON/OFF button MODE button TIMER button Display Inserting or replacing the batteries · Remove the cover on the rear of the remote control; · Insert two LR03 "AAA" 1. 5V batteries, making sure they are in the correct position (see the instructions inside the battery compartment); · Replace the cover. 21 20 19 If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in accordance with current legislation as they are harmful to the environment. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Batteries may explode or leak. 17 18 10 Using the remote control unit TURNING THE APPLIANCE ON Plug the appliance into an electrical socket. Press the ON/OFF button (18) (when turned on, the air conditioner starts operating in the same mode as when it was turned off). Press the MODE button (19) to select the required mode AIR-CONDITIONING (COOL) DEHUMIDIFYING (DRY) FAN ONLY (FAN) An arrow on the display indicates the selected mode. AIR-CONDITIONING MODE (COOL) Ideal for hot humid weather when you need to cool and dehumidify the room. In air-conditioning mode, use the buttons to select the desired temperature. [. . . ] END OF SEASON OPERATIONS To empty the internal circuit completely of water, remove the cap (figure I). When all the water has been drained, put the cap back in place. Clean the filter and dry thoroughly before putting back. I H 14 Self-diagnosis/Troubleshooting SELF-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. IF . . . IS DISPLAYED . . . WHAT SHOULD YOU DO? When the appliance is operating in dehumidifying mode and appears on the display, the ice prevention device has been triggered. [. . . ]