User manual DELONGHI PACF 11

[. . . ] · Do not pull on or place strain on the power cable when moving the appliance. · The appliance should not be installed where the atmosphere may contain combustible gases, oil or sulphur, or near heat sources. · Do not rest hot or heavy objects onto the appliance. · Clean the filters at least once a week. [. . . ] AIR CONDITIONING FUNCTION The unit is turned off, the function selector 11 is in the "O" position. To turn the unit on in air conditioning mode, proceed as follows: 1. Rotate the function selector dial clockwise: · Place the large star symbol in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed. · Place the small star symbol in line with the reference mark to operate the unit in air conditioning mode at minimum fan speed. Now set the required temperature by rotating the room thermostat dial 13 . reference mark to operate the unit in air purification mode at maximum fan speed. · Place the small symbol in line with the reference mark to operate the unit in air purification mode at minimum fan speed. TURNING OFF To turn the unit off completely, set the function selector to the "O" position and unplug from the mains THIS UNIT EMPLOYS AN EXCLUSIVE CONDENSATION RECYCLING SYSTEM TO DISPOSE OF EXCESS MOISTURE. IN NORMAL CONDITIONS, CONDENSATION IS DISPOSED OF AUTOMATICALLY. WHEN THE HUMIDITY IS PARTICULARLY HIGH, AN EXCESS OF CONDENSATION MAY BUILT UP IN THE TANK 8 . . HAPPENS, THE INDICATOR LIGHT COMES ON INDICATING THAT THE TANK SHOULD BE EMPTIED. ONLY FOR SOME MODEL IN EXTREME CASE IF THIS PROBLEM IS CURRENT YOU MAY DISCHARGE THE EXCESS WATER FROM THE TANK 8 DIRECTLY INTO A DRAIN. USE THE RUBBER TUBE WITH AN INTERNAL DIAMETER OF 12 mm. THE TUBE SHOULD BE INSERTED INTO THE HOLE PROVIDED AFTER REMOVING THE RUBBER BUNG MAKE SURE THE TANK 8 . IS PUT BACK CORRECTLY OTHERWISE THE LIGHT 12 . THE INTERNAL TANK CAN ALSO BE DRAINED BY REMOVING THE BUNG FROM THE DRAIN HOSE 9 INTO A SUITABLE RECEPTACLE. Regulation of the thermostat The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. When the desired room temperature has been reached, slowly turn the thermostat in a clockwise direction until it arrives at the position where a click can be heard. The temperature selected in this way will automatically be regulated and maintained, and save energy. When regulating the thermostat, the air conditioning function is temporarily interrupted and the unit continues to operate in fan only mode. VENTILATION Rotate the function selector 11 anticlockwise. · Place the large symbol in line with the 8 DELAY ON START UP 1 A special safety device will delay the start of air conditioning by aproximately 3 minutes when switching between functions or on initial start up. [. . . ] Take out the condensation tank 8 located in the rear of the unit and empty it. After replacing the bung, put the condensation tank back. Clean the filters and dry well before replacing. Protect the unit from dust by covering with a plastic bag. 10 5751005200NZ 29-09-2000 13:36 Pagina 11 Troubleshooting If the unit is not working properly, this may be due to small problems that you can easily resolve yourself. [. . . ]