User manual DELONGHI PACF 110R/W

[. . . ] · Do not pull on or place strain on the power cable when moving the appliance. · The appliance should not be installed where the atmosphere may contain combustible gases, oil or sulphur, or near heat sources. · Do not rest hot or heavy objects onto the appliance. · Clean the filters at least once a week. [. . . ] The brown wire must be connected to the terminal marked with the letter L or coloured red. ENGLISH · Fit the flange 14 supplied to the hole. · Fix the hose 15 to the coupling on the back of the unit (figure A). · Attach the end of the hose 15 to the flange 14 as shown in the figure F. F110 4-04-2003 11:10 Pagina 16 Turning on and Selecting functions ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the power supply shown on the rating plate; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug 10 , otherwise have the socket replaced; · the socket is properly earthed. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. AIR CONDITIONING FUNCTIONS The unit is turned off, the function selector 11 is in the "O" position. To turn the unit on in air conditioning mode, proceed as follows: 1. Rotate the function selector dial clockwise: · Place the large star symbol in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed. · Place the small star symbol in line with the reference mark to operate the unit in air conditioning mode at minimum fan speed. Now set the required temperature by rotating the room thermostat dial 13 . reference mark to operate the unit in air purification mode at maximum fan speed. · Place the small symbol in line with the reference mark to operate the unit in air purification mode at minimum fan speed. TURNING OFF To turn the unit off completely, set the function selector to the "O" position and unplug from the mains THIS UNIT EMPLOYS AN EXCLUSIVE CONDENSATION RECYCLING SYSTEM TO DISPOSE OF EXCESS MOISTURE. IN NORMAL CONDITIONS, CONDENSATION IS DISPOSED OF AUTOMATICALLY. WHEN THE HUMIDITY IS PARTICULARLY HIGH, AN EXCESS OF CONDENSATION MAY BUILT UP IN THE TANK 8 . . HAPPENS, THE INDICATOR LIGHT COMES ON INDICATING THAT THE TANK SHOULD BE EMPTIED. ONLY FOR SOME MODEL IN EXTREME CASE IF THIS PROBLEM IS CURRENT YOU MAY DISCHARGE THE EXCESS WATER FROM THE TANK 8 DIRECTLY INTO A DRAIN. USE THE RUBBER TUBE WITH AN INTERNAL DIAMETER OF 12 mm. THE TUBE SHOULD BE INSERTED INTO THE HOLE PROVIDED AFTER REMOVING THE RUBBER BUNG MAKE SURE THE TANK 8 . IS PUT BACK CORRECTLY OTHERWISE THE LIGHT 12 . THE INTERNAL TANK CAN ALSO BE DRAINED BY REMOVING THE BUNG FROM THE DRAIN HOSE 9 INTO A SUITABLE RECEPTACLE. Regulation of the thermostat The temperature is not expressed in degrees. We recommend that you turn the thermostat dial to the maximum position. [. . . ] If very dirty, rinse repeatedly in warm water at a temperature of not more than 40° C. To replace, put the filters back into the intake grill, then hook the latter to the unit. START OF SEASON CHECKS Check that the power cable and socket are undamaged and that the earth installation is efficient. Carefully observe the installation instructions. 2 1 fig. [. . . ]