User manual DELONGHI PACFX 160ECO

[. . . ] FX160/400ECO GB 20-06-2002 16:51 Pagina 21 Important Safe-guards · This appliance has been manufactured to cool and de-humidify domestic environments and should not be used for other purposes. · It is dangerous to alter or modify the unit's characteristics in any way. · The appliance must be installed in conformity with the relevant national legislation. · Should repairs be necessary, contact the nearest authorised Repair Service Centre. [. . . ] In this case, use the belts (14) supplied; hook these to the eyes (15); before inserting the eyes, remove the rubber seals. 15 11 The external unit can also be hung on a wall using the brackets (12). Proceed as follows: 1) FFix the bracket to the wall 12 taking care to position it as indicated in fig. (For the holes, use the jig on the cover of the polystyrene packaging); The external unit may be installed above or at the same level as the internal unit, provided that the difference in level is not greater than 1. 5m. the air intake and discharge of the external unit must be kept clear of obstacles. Leave at least 6 cm between the wall and the appliance. Condensation forming during operation is eliminated via evaporation from the external unit. In particular cases, if there is excessive humidity, to eliminate condensation the drain coupling must be used. This should be mounted on the base of the external unit (see fig. 16) after removing the rubber Seal seal. The external 16 unit should be protected from the sun, rain, snow and Wheel drips from the roof. Coupling 27 ENGLISH 2) Screw the support blocks (13) to the external unit using the M4 screws (17) (taking care to position them with the hole for the screw on top). 13 FX160/400ECO GB 20-06-2002 16:51 Pagina 28 Description of the control panel THE DISPLAY A. Function Button Air-conditioning, dehumidifying, ventilation C. Increase temperature button / increase operating time button G. Decrease temperature button / Decrease operating time button H. Display Displays the temperature selected, time programmed and (Model FX400ECO only) the room temperature. Display room temperature button (FX400ECO) ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the value shown in the specifications table; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug, otherwise have the socket replaced; · the socket is properly grounded. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. 28 FX160/400ECO GB 20-06-2002 16:51 Pagina 29 Operation SWITCHING THE APPLIANCE ON Connect the appliance to the mains supply. The appliance will automatically select the correct fan mode. 29 ENGLISH FX160/400ECO GB 20-06-2002 16:51 Pagina 30 Operation VENTILATION/PURIFICATION This is ideal for dusty or polluted areas; in effect, the appliance recycles and purifies the air using the dust filters and 3M FiltreteTM electrostatic filters fitted. Adjust the fan speed by pressing the "FAN" (Q) button, as illustrated in the air conditioning function. Bear in mind that the higher the speed, the greater the volume of air filtered; by selecting the "Silent" speed, less air is filtered, but the noise level is low. "AUTO" function cannot be selected in this mode. The display will show the fan speed selected. [. . . ] The installation instructions should be observed meticulously. END OF SEASON OPERATIONS Empty the water from the tank. FX160ECO: Remove the tank (9) and empty it. To drain any residual water from the internal circuit, remove the stopper (11) from the drain tube (10) and drain completely. [. . . ]