User manual DELONGHI PACT 06ECO

[. . . ] IMPORTANT SAFEGUARDS GB · Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. · This appliance is designed for home air conditioning and must not be used for other purposes · It is dangerous to modify or alter the characteristics of the appliance in any way. · The appliance must be installed in conformity with national legislation regulating electrical equipment and installations. [. . . ] Always press the button, then wait for a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation. 25 13 AIR CONDITIONING MODE (FIG. 13) Ideal for hot muggy weather when you need to cool and dehumidify the room. To set this mode correctly: · Press the MODE button a number of times until the air-conditioning symbol appears. · Select the target temperature by pressing the + or - button until the corresponding value is displayed. · Select the required fan speed by pressing the FAN button. Four speeds are available: High speed: to achieve the target temperature as rapidly as possible Medium speed: reduces noise levels but still maintains a good level of comfort Low speed: for silent operation Auto speed: the appliance automatically selects the most suitable fan speed in relation to the temperature set on the digital display. The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outdoor temperature. 14) Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). Place the appliance in the room without fitting the air exhaust hose. To set this mode correctly: · Press the MODE button a number of times until the dehumidifying symbol appears, then press the + or - button until the required humidity level is displayed. At the same time, the Auto fan light comes on as the appliance automatically selects the most appropriate speed. Water is removed from the air and collected in the tank at the back of the air conditioner. When the tank is full, the appliance shuts down and (full tank) appears on the display. The tank must be extracted and emptied (fig. When the tank has been emptied, the appliance starts up again. The remote control must be no more than 7 metres away from the appliance (without obstacles between the remote control and the receiver). The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat. MAX. 7 metres 28 INSERTING OR REPLACING THE BATTERIES · Remove the cover on the rear of the remote control (fig. 19); · Insert two R03 "AAA" 1. 5V batteries in the correct position (see instructions inside the battery compartment); · Replace the cover. 19 If the remote control unit is replaced or disposed of, the batteries must be removed and discarded in accordance with current legislation as they are harmful to the environment. SETTING THE TIME After having inserted the batteries, the clock on the display flashes until the time is set. [. . . ] To use the 3M® electrostatic filter: A) Remove the intake grille B) Remove the filter from the packaging C)Use the two plastic edges of the 3M filter to hook it to the special attachments on the dust filter already inside the intake grille. D) Replace the grille on the appliance. Silver ion filter Intake grille 32 CLEANING Before cleaning or maintenance, turn the appliance off by pressing the button on the control panel or remote control, wait for a few minutes then unplug from the mains socket. CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. Never wash the air conditioner with water. Never use petrol, alcohol or solvents to clean the appliance. Never spray insecticide liquids or similar. CLEANING THE AIR FILTERS To keep your air conditioner working efficiently, you should: 1. Clean the silver ion filter every week of operation. [. . . ]