User manual DELONGHI PACT 10HP

[. . . ] IMPORTANT SAFEGUARDS GB · Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. · This appliance is designed for home air conditioning and must not be used for other purposes · It is dangerous to modify or alter the characteristics of the appliance in any way. · The appliance must be installed in conformity with national legislation regulating electrical equipment and installations. [. . . ] 14) Ideal to reduce room humidity (spring and autumn, damp rooms, rainy periods, etc). Place the appliance in the room without fitting the air exhaust hose (L). To set this mode correctly: · Press the MODE button a number of times until the dehumidifying symbol (4) appears, then press the + or - button until the required humidity level is displayed. At the same time, the Auto fan light comes on as the appliance automatically selects the most appropriate speed. Water is removed from the air and collected in the tank at the back of the air conditioner. When the tank is full, the appliance shuts down and (full tank) appears on the display. The tank must be extracted and emptied (fig. When the tank has been emptied, the appliance starts up again. The accessory continuous drain hose enables the condensate produced to be eliminated without requiring the tank to be emptied periodically. Fit the hose with the rapid coupling as shown in fig. NB: In order for the continuous drain function to operate correctly, make sure the accessory is fully connected to the coupling. 16 15 26 AIR PURIFYING/FAN MODE (FIG. 17) When using the appliance in this mode, the air exhaust hose does not need to be attached. To set this mode correctly: · Press the MODE button a number of times until the fan symbol appears. · Select the required fan speed by pressing the FAN button. Three speeds are available: High speed: for maximum fan power Medium speed: reduces noise levels but still maintains a good level of comfort Low speed: for silent operation In this mode, AUTO speed cannot be selected. 17 18 HEATING MODE (FIG. 18) To set this function correctly: · Press the MODE button a number of times until the heating symbol (6) appears. · Select the required temperature by pressing the + or - button until the corresponding value is displayed. · In heating mode, the fan speed is selected automatically by the appliance. Water is removed from the air and collected in the tank at the back of the air conditioner. When the tank is full, the appliance shuts down and " " (full tank) appears on the display. The tank must be extracted and emptied (fig. [. . . ] D) Replace the grille on the appliance. 3M® filter Silver ion filter Intake grille 32 CLEANING Before cleaning or maintenance, turn the appliance off by pressing the button on the control panel or remote control, wait for a few minutes then unplug from the mains socket. CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. Never wash the air conditioner with water. Never use petrol, alcohol or solvents to clean the appliance. Never spray insecticide liquids or similar. CLEANING THE AIR FILTERS To keep your air conditioner working efficiently, you should: 1. Clean the silver ion filter every week of operation. Replace the 3M® air purifying filter at the end of each season or when exhausted (see the instructions near the filter housing on the appliance). [. . . ]