User manual DELONGHI PINGUINO L15

[. . . ] L10/L15/L20H/L30/L40 · Istruzioni per l'uso . . pag. 4 19 34 49 64 79 94 · Mode d'emploi et d'entretien . · Manual de instruções . . pag. · ËÁ>Â~ ¯Ú<ÛË~ Î·È ÛÓÙ<ÚËÛË~ . [. . . ] C). A · Fit the window outlet 11 to the end of the hose 12 . · Place the air conditioning unit near a window or French window. · Make sure the air exhaust hose is unobstructed. · Open the window or French window slightly and position the outlet 12 as shown in figure B. Keep air hoses as short and free of curves as possible to avoid constrictions. C 21 Pre p a r i n g f o r u s e AIR-CONDITIONING WITH INSTALLATION If required, the Pinguino can also be installed semi-permanently (Fig. · Fit the flange accessory the hole 10 provided in · Fit the hose 11 in the housing at the back of the appliance (fig. · Fit the end of the hose 11 to the flange 10 as shown in fig. F. F MAX100 cm 30 cm MIN 35 c 30 cm D Proceed as follows: · Drill a hole in an outside wall or through a window pane. Respect the height and dimensions of the hole given in figure E. When the hose 11 is not fitted, the hole can be closed with the flange cap 10 . NOTE. When installing the air conditioning unit semipermanently, you should leave a door slightly open (as little as 1 cm) to guarantee correct ventilation. in the window pane 106 in the wooden kickboard of a French window E in the wall: you are recommended to insulate the section of wall using suitable insulation. Keep the air hoses as short and free of curves as possible to avoid constrictions. 22 Control panel L10/L15/L20H MODELS L10/ L15/L20H THE CONTROL PANEL I M HG F C B A P N LO Q E D DESCRIPTION OF THE CONTROL PANEL A ON/OFF button B Mode selection button Conditioning, fan, heating (L20H only). The "AUTO" light (O) on the control panel comes on. SETTING THE TIMER The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by optimising operating periods How to programme delayed start up · Plug the appliance into a mains socket and press the ON/OFF (A) button, then select the required operating mode and other settings (temperature, fan speed, etc). · Press the ON/OFF (A) button again to place the appliance in standby mode. The two centre segments flash on the display. · Use the "+" (F) o "-" (I) buttons to set the number of hours delay before the appliance comes on. The setting is increased or decreased by an hour at a time; however, when the buttons are held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait a few seconds for the data to be acquired. The indicator light (G) flashes until the appliance starts up. You can set the appliance to come on with a delay of up to 24 hours. To cancel the timer setting, press the timer button (Q), and use the "-" button (I) to set the time to zero. The indicator light (G) will stop flashing. [. . . ] CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. For safety reasons, never wash the air conditioning unit with water. Precautions Never use petrol, alcohol or solvents to clean the appliance. Never spray insecticide liquids or similar. [. . . ]